The website uses cookies to provide personalized services at the highest level, including statistical services and to adapt the content to individual preferences of users. Saving cookies can be turned off in your browser settings.
OK
[zamknij]     

Loctite SF 7414-50ml (chemical seal, blue)

Product description:
LOCTITE 7414 is a fast drying paste to be used in production to visually detect any movement in the adjustment of parts. LOCTITE 7414 has been developed for use on compression fittings, studs, nuts, parts and assemblies after they have been set to proper tension or position. Service personnel or inspectors can quickly spot any changes or tampering with equipment. It has excellent adhesion to metals, including aluminum, magnesium, titanium, stainless steel and copper, and is non-corrosive to these metals. This product should be typically applied in temperatures from 15 to 25 °C, higher temperatures will reduce the drying time. Operating temperatures range from -35 to +145 °C. Further information on the product can be obtained from the local technical department: biuro@woronko-loctite.pl

Directions for use:
1. Squeeze the tube to extrude the paste through the small hole to form a bead (narrow stripe) across the parts.
2. The surface dries in about 1 minute and becomes brittle as it dries completely.
3. LOCTITE SF 7414 dries to form skin very quickly and should be sealed adequately after every use.

Storage:
StorageThe product is classified as flammable and must be stored in an appropriate manner in compliance with relevant regulations. Do not store near oxidizing agents or combustible materials. Store product in the unopened container in a dry location. Storage information may also be indicated on the product container labelling. Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties. Material removed from containers may be contaminated during use. Do not return product to the original container. Henkel cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.

Parameters:
  • Specific Gravity at 25 °C : 1.4
  • Dry surface time, seconds : 60 to 120
  • Chemical type : solvent
  • Appearance : blue high viscous paste
  • Odor : xylene

    Full technical information can be found in the technical data sheet
  • Assortment