The website uses cookies to provide personalized services at the highest level, including statistical services and to adapt the content to individual preferences of users. Saving cookies can be turned off in your browser settings.
OK
[zamknij]     

LOCTITE MR 3020 - 400ml spray (positioning of the seals)

LOCTITE MR 3020 - 400ml spray (positioning of the seals) (IDH.458645)

Product description:
LOCTITE 3020 is a liquid, in an aerosol can, formulated as an adhesive/sealant which dries quickly to form a highly tacky film. It is designed for holding pre-cut gaskets in place during assembly and improves sealing and gasket preformance in operation. This product is recommended for use on all types of pre-cut gaskets including transmission gaskets, head gaskets, clutch assembly and differential gaskets made of rubber, cork, paper, metal and asbestos. Further information about the product: biuro@woronko-kleje.pl

Directions for use:
1. Clean and dry flange and gasket surfaces. Use a suitable cleaner such as LOCTITE SF 7063.
2. Spray an even coat of LOCTITE 3020 from a distance of about 15 to 20 cm onto the flange surface and on both sides of the gasket.
3. Allow approximately 10 minutes drying time before assembly.
4. Excess product can be removed with a suitable cleaner such as LOCTITE 7063.

Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties. Material removed from containers may be contaminated during use. Do not return product to the original container.
Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.

Parameters:
  • Specific Gravity at 25 °C : 0.832 to 0.844
  • Solids/Non-Volatile Content, % : 26 to 27
  • Refractive index : 1.398 to 1.41
  • Application : gasketing
  • Specific Benefit:
  • No ozone-depleting solvents
  • Resistant to gasoline, diesel, water, grease and oils
  • Dries quickly to form a highly tacky elastomeric film
  • Remains tacky indefinitely

    Full technical information can be found in the technical data sheet.
  • Assortment