Try to find the solution
Loctite LB 8040 - 400 ml, spray (loosening oil, Freeze & Release)
No.
IDH.700846
Price
Loctite LB 8040 - 400 ml, spray (loosening oil, Freeze & Release)
Product description:
LOCTITE LB 8040 is a special mineral oil formulation to free rusted, corroded and seized parts. The shock-freezing effect from a stream of lubricant at -43°C will instantly cool parts and cause microscopic cracks in the layer of rust. This allows the lubricating ingredients to wick directly into the rust by capillary action. Released parts remain lubricated and protected from corrosion. Further information on the product can be obtained from your local technical department: biuro@woronko-loctite.pl
Directions for use:
1. Remove dirt and loose rust from parts.
2. Shake can thoroughly. Spray at a distance of about 10 to 15 cm onto the fastener to be treated for 5 to 10 seconds.
3. Allow the product to react for 1 to 2 minutes, before attempting to release the seized part.
4. Repeat application if necessary.
Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product containerlabeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties. Material removed from containers may be contaminated during use. Do not return product to the original container.
Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:
Full technical information can be found in the technical data sheet.
LOCTITE LB 8040 is a special mineral oil formulation to free rusted, corroded and seized parts. The shock-freezing effect from a stream of lubricant at -43°C will instantly cool parts and cause microscopic cracks in the layer of rust. This allows the lubricating ingredients to wick directly into the rust by capillary action. Released parts remain lubricated and protected from corrosion. Further information on the product can be obtained from your local technical department: biuro@woronko-loctite.pl
Directions for use:
1. Remove dirt and loose rust from parts.
2. Shake can thoroughly. Spray at a distance of about 10 to 15 cm onto the fastener to be treated for 5 to 10 seconds.
3. Allow the product to react for 1 to 2 minutes, before attempting to release the seized part.
4. Repeat application if necessary.
Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product containerlabeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties. Material removed from containers may be contaminated during use. Do not return product to the original container.
Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:
- Technology : lubricants
- Chemical type : mineral oilColor : amberCure : not applicableApplication : rust treatmentDispense Method : sprayKey substrates : metalsDensity (20 °C), g/ml : 0,6Maximum chill down, °C : -43Lubricant viscosity, mPa·s (cP) : <5
Full technical information can be found in the technical data sheet.
