The website uses cookies to provide personalized services at the highest level, including statistical services and to adapt the content to individual preferences of users. Saving cookies can be turned off in your browser settings.
OK
[zamknij]     

LOCTITE 5776 - 50ml (anaerobic, yellow, medium strength thread sealant)

LOCTITE 5776 - 50ml (anaerobic, yellow, medium strength thread sealant) (IDH.1448091)

Product description:
LOCTITE 5776 is designed for the locking and sealing of metal threaded pipes and fittings. The product cures when confined in the absence of air between close fitting metal surfaces and prevents loosening and leakage from shock andvibration. The thixotropic nature of LOCTITE 5776 reduces the migration of liquid product after application to the substrate. Further information about the product: biuro@woronko-kleje.pl

Steps to achieve the best adhesive results:
FOR ASSEMBLY:
1. For best results, clean all surfaces (external and internal) with a LOCTITE SF 7063 cleaning solvent and allow to dry.
2. If the material is an inactive metal or the cure speed is too slow, use appropriate activator LOCTITE 7649 or LOCTITE 7471. Please see the Cure Speed vs. Activator graph for reference. Allow the activator to dry when needed.
3. Apply a 360° bead of product to the leading threads of the male fitting, leaving the first thread free. Force thematerial into the threads to thoroughly fill the voids. For bigger threads and voids, adjust product amount accordingly and apply a 360° bead of product on the female threads also.
4. Using compliant practices, assemble and wrench tighten fittings in accordance with manufacturers recommendations.
5. Properly tightened fittings will seal instantly to moderate pressures. For maximum pressure resistance and solvent resistance allow the product to cure a minimum of 24 hours.

FOR DISASSEMBLY:
6. Remove with standard hand tools.
7. Where hand tools do not work because of excessive engagement length or large diameters (over 1"), apply localized heat to approximately 250 °C (480F). Disassemble while hot.

FOR CLEAN UP:
8. Cured product can be removed with a combination of soaking in a LOCTITE SF 7200 solvent and mechanical abrasion such as a wire brush.

Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties. Material removed from containers may be contaminated during use. Do not return product to the original container.
Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other thanthose previously indicated.

Parameters:
  • Strength : medium
  • Viscosity : medium
  • Time to get full strength (25 °C):
    -Steel : 30 minutes
    -Brass : 5 minutes
    -Zinc dichromate : 1 hour
    -Stainless steel : 30 minutes
  • Time to obtain initial strength (25 °C):
    -Steel : 72 hours
    -Brass : 24 hours
    -Zinc dichromate : 72 hours
    -Stal nierdzewna : 72 hours
  • Working temperature : -55 °C do 150 °C
  • Thread size : to R3"/M80
  • Breakaway Torque : 9 Nm


Full information can be found in the technical data sheet.

Assortment