LOCTITE 425 - 20g (low-strength instant adhesive for locking metal and plastic fasteners)
No.
IDH.135461
Files to download:
LOCTITE 425 - 20g (low-strength instant adhesive for locking metal and plastic fasteners)
Product description:
LOCTITE® 425™ is designed as a fast curing, low strength adhesive for locking metal and plastic fasteners. The product is designed for pre- or post-application. LOCTITE® 425™ cures quickly on plated metal and plastics fasteners; fixturing is achieved in less than 2 minutes and full strength within 24 hours. This product is commonly used for tamperproofing the head of screws or potentiometers. Fixture speed can be increased by application of a LOCTITE® Cyanoacrylate activator - e.g. 7113™. This product is typically used in applications with an operating range of -54 °C to +85 °C.
Directions for use:
1. For best performance bond surfaces should be clean and free from grease.
2. This product performs best in thin bond gaps (0.05 mm).
3. Excess adhesive can be dissolved with Loctite cleanup solvents, nitromethane or acetone
Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling. Optimal Storage: 2 °C to 8 °C. Storage below 2 °C or greater than 8 °C can adversely affect product properties. Material removed from containers may be contaminated during use. Do not return product to the original container. Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated. If additional information is required, please contact your local Technical Service Center or Customer Service Representative.
Parameters:
Specific Gravity at 25 °C : 1.1 Viscosity, Brookfield - LVF, 25 °C, mPa·s (cP), Spindle 1, speed 30 rpm, : 40 to 80 Appearance : Dark blue liquid Components : One part - requires no mixing Viscosity : Low Cure : Humidity Application : Low strength threadlocking / retaining Key Substrates : Metals and Plastics
Further information can be found in Technical Data Sheet
LOCTITE® 425™ is designed as a fast curing, low strength adhesive for locking metal and plastic fasteners. The product is designed for pre- or post-application. LOCTITE® 425™ cures quickly on plated metal and plastics fasteners; fixturing is achieved in less than 2 minutes and full strength within 24 hours. This product is commonly used for tamperproofing the head of screws or potentiometers. Fixture speed can be increased by application of a LOCTITE® Cyanoacrylate activator - e.g. 7113™. This product is typically used in applications with an operating range of -54 °C to +85 °C.
Directions for use:
1. For best performance bond surfaces should be clean and free from grease.
2. This product performs best in thin bond gaps (0.05 mm).
3. Excess adhesive can be dissolved with Loctite cleanup solvents, nitromethane or acetone
Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling. Optimal Storage: 2 °C to 8 °C. Storage below 2 °C or greater than 8 °C can adversely affect product properties. Material removed from containers may be contaminated during use. Do not return product to the original container. Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated. If additional information is required, please contact your local Technical Service Center or Customer Service Representative.
Parameters:
Further information can be found in Technical Data Sheet
