The website uses cookies to provide personalized services at the highest level, including statistical services and to adapt the content to individual preferences of users. Saving cookies can be turned off in your browser settings.
OK
[zamknij]     
The product is available while stocks last. Will be replaced by Teroson BOND ALL-IN-ONE-PRIMER

Product description:
TEROSON PU 8519P is a thin liquid, solvent containing masking aid based on polyurethane. The product is notable for its excellent covering properties and its good UV-stability. It is free from chlorinated hydrocarbons and aromatic solvents. TEROSON PU 8519P is used e.g. for masking bus bars for heated windshields made of laminated glass. The primer/ activator is also suitable for promoting the adhesion of other PUR adhesives/sealants to glass, glass caramic, various plastics and metals (trials must be carried out prior to use). TEROSON PU 8519P can also be used as activator for PUR-coated glasses and for remaining beads. TEROSON PU 8519P is also suitable as corrosion protection for small flange damages. Further information on the product can be obtained from the local technical department: biuro@woronko-loctite.pl

Directions for use:
Prior to use, shake the aluminum bottle vigorously by hand for at least 1 minute. A steel ball is provided in the bottle to assist mixing. This should move freely after three to four shakes. TEROSON PU 8519P may be applied thinly and evenly with felt applicator, sponge or brush. Ensure the wet film should be 0.025 mm. Let the primed surface evaporate for approx. 2 minutes before the direct glazing sealant is applied. A second application on the same point should be avoided, as partiallydried primer will be softened again which can adversely affect appearance. The optimal application temperature is between 0 to 30 °C. In exceptional cases the application can be done at higher temperatures. A higher reaction speed will be noticed.

Storage:
  • Frost sensitive : no
  • Recommended storage temperature : 5 to 25 °C
  • Shelf life up to : 18 months depending on packaging

    Parameters:
  • Colour : black
  • Odour : smells of solvent
  • Consistency : thin liquid
  • Density : 0.98 g/cm³
  • Solids : 35 %
  • Drying time (1C adhesive) : > 2 min.
  • Drying time (2C adhesive) : > 15 min.
  • Primer activity on pre-coatings and remaining beads : up to 60 min. after application
  • Open time : max.8 hr(s)
  • In service temperature range : -40 to 90 °C short exposure (up to 3 h) 120 °C

    Full technical information can be found in the technical data sheet
  • Assortment