Try to find the solution
TEROSON PU 9500 FOAM - 200ml (soundproofing foam for closed profiles)
No.
IDH.939813
Associated products:
TEROSON PU 9500 FOAM - 200ml (soundproofing foam for closed profiles)
Associated products:
Product description:
TEROSON PU 9500 FOAM is a ready-to-use, expanding cavity-filling and sounddeadening foam supplied in an aerosol can. Due to its extended skin-formation time, foaming can be interrupted briefly for up to 5 minutes during application and then resumed. The foam cures without the need of moisture and is thus suitable for filling cavities. The cured foam does not subsequently swell or shrink. Further information about the product: biuro@woronko-kleje.pl
Directions for use:
1. Remove the safety catch from the activation lid.
2. Use the wire to pull the activation lid out as far as it will go (about 11 cm as far as notch).
3. Break off wire at the intended break point (notch) above the valve.
4. Screw plastic adapter into valve.
5. Shake can vigorously up and down.
6. Apply foam with valve pointing downward.
7. About 0.25 liters of foam is extruded per second of foaming time, for free foaming. After activation, always release at least some of the foam. Use sparingly as the foam expands by about 50 to 100% without confinement and by about 100 to 200% in cavities.
Storage:
Frost sensitive : yes Recommended storage temperature : 15 to 25 °C Shelf life : 12 months in original packaging
Parameters:
Mixing : shake about 20 times Colour : silver grey Starting time : approx. 5 s Expansion volume : up to 100 % Tack-free-time : 15 to 17 min* Cuttable after : >25 min.* Shear strength after 24h : 7 N/cm² Optimal application temperature : 18 to 23 °C Application temperature : 10 to 35 °C
Full technical information can be found in the technical data sheet.
TEROSON PU 9500 FOAM is a ready-to-use, expanding cavity-filling and sounddeadening foam supplied in an aerosol can. Due to its extended skin-formation time, foaming can be interrupted briefly for up to 5 minutes during application and then resumed. The foam cures without the need of moisture and is thus suitable for filling cavities. The cured foam does not subsequently swell or shrink. Further information about the product: biuro@woronko-kleje.pl
Directions for use:
1. Remove the safety catch from the activation lid.
2. Use the wire to pull the activation lid out as far as it will go (about 11 cm as far as notch).
3. Break off wire at the intended break point (notch) above the valve.
4. Screw plastic adapter into valve.
5. Shake can vigorously up and down.
6. Apply foam with valve pointing downward.
7. About 0.25 liters of foam is extruded per second of foaming time, for free foaming. After activation, always release at least some of the foam. Use sparingly as the foam expands by about 50 to 100% without confinement and by about 100 to 200% in cavities.
Storage:
Parameters:
Full technical information can be found in the technical data sheet.
