LOCTITE FREKOTE 909 WB - 1 KG (mold cleaner)
No.
IDH.1252381
LOCTITE FREKOTE 909 WB - 1 KG (mold cleaner)
Product description:
LOCTITE FREKOTE 909WB™ is a high alkaline stripper foam based on potassium hydroxide. LOCTITE FREKOTE 909WB™ removes release agent coats from molds made from steel, nickel, chemical plated nickel and cast iron. Due to its alkaline base the cleaner should not be used on aluminium molds. Further information about product you can receive from local technical department: biuro@woronko-kleje.pl
Directions for use:
1. Apply LOCTITE FREKOTE 909WB™ with a clean, lint free cotton or non-woven wiping cloth. Wet the cloth with LOCTITE FREKOTE 909WB™ until it is damp but not dripping.
2. Leave the film on the surface for approximately 1 hour. The cleaner begins to foam and is softening the contamination.
3. For a defined surface rinse the mold with a solvent like Frekote® PMC™.
4. The mold is now ready to be coated with a new release agent.
Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling. Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties. Material removed from containers may be contaminated during use. Do not return product to the original container. Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:
Technology : Cleaner Appearance : Yellow Chemical Type : Alkaline stripper Odor : Mild citrus Cure : Room temperature cure Application : Temperature : 20 to 40 °C Application: Mold cleaning Specific Benefit:
● Easy application
● Removes cured release agents
● Water-based
● Non-flammable
Further information can be found in technical data sheet
LOCTITE FREKOTE 909WB™ is a high alkaline stripper foam based on potassium hydroxide. LOCTITE FREKOTE 909WB™ removes release agent coats from molds made from steel, nickel, chemical plated nickel and cast iron. Due to its alkaline base the cleaner should not be used on aluminium molds. Further information about product you can receive from local technical department: biuro@woronko-kleje.pl
Directions for use:
1. Apply LOCTITE FREKOTE 909WB™ with a clean, lint free cotton or non-woven wiping cloth. Wet the cloth with LOCTITE FREKOTE 909WB™ until it is damp but not dripping.
2. Leave the film on the surface for approximately 1 hour. The cleaner begins to foam and is softening the contamination.
3. For a defined surface rinse the mold with a solvent like Frekote® PMC™.
4. The mold is now ready to be coated with a new release agent.
Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling. Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties. Material removed from containers may be contaminated during use. Do not return product to the original container. Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:
● Easy application
● Removes cured release agents
● Water-based
● Non-flammable
Further information can be found in technical data sheet