LOCTITE 420 - 20g (universal cyanoacrylate adhesive (instant), colorless/transparent)
No.
IDH.1920918
Product description:
LOCTITE 420 is a general purpose cyanoacrylate instant adhesive. LOCTITE 420 is tested to the lot requirements of Military Specification Mil-A-46050C. Note: This is a regional approval. Please contact your local Technical Service Center for more information and clarification. LOCTITE 420 has been qualified to Commercial Item Description A-A-3097. Note: This is a regional approval. Please contact your local Technical Service Center for more information and clarification. Further information about the product: biuro@woronko-kleje.pl
Steps to achieve the best adhesive results:
1. For best performance bond surfaces should be clean and free from grease. Use LOCTITE SF 7063.
2. This product performs best in thin bond gaps (0,05 mm).
3. Excess adhesive can be dissolved with Loctite cleanup solvents, nitromethane or acetone.
Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.
Optimal Storage: 2 °C to 8 °C. Storage below 2 °C or greater than 8 °C can adversely affect product properties.
Material removed from containers may be contaminated during use. Do not return product to the original container.
Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:
Tensile shear strength, ASTM D1002, DIN 53283, N/mm² :
Full technical information can be found in the technical data sheet.
LOCTITE 420 is a general purpose cyanoacrylate instant adhesive. LOCTITE 420 is tested to the lot requirements of Military Specification Mil-A-46050C. Note: This is a regional approval. Please contact your local Technical Service Center for more information and clarification. LOCTITE 420 has been qualified to Commercial Item Description A-A-3097. Note: This is a regional approval. Please contact your local Technical Service Center for more information and clarification. Further information about the product: biuro@woronko-kleje.pl
Steps to achieve the best adhesive results:
1. For best performance bond surfaces should be clean and free from grease. Use LOCTITE SF 7063.
2. This product performs best in thin bond gaps (0,05 mm).
3. Excess adhesive can be dissolved with Loctite cleanup solvents, nitromethane or acetone.
Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.
Optimal Storage: 2 °C to 8 °C. Storage below 2 °C or greater than 8 °C can adversely affect product properties.
Material removed from containers may be contaminated during use. Do not return product to the original container.
Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:
Tensile shear strength, ASTM D1002, DIN 53283, N/mm² :
- Steel (sand-blasted):15 to 26
- Aluminum (sand-blasted): 12 to 19
- Zinc dichromate: 6 to 13
- ABS:6 to 20
- PCV: 6 to 20
- Polycarbonate: 5 to 20
- Phenolic : 5 to 15
- Neoprene rubber : 5 to 15
- Nitrile rubber : 5 to 15
- Steel: 12 to 25
- Buna N gum : 5 to 15
Full technical information can be found in the technical data sheet.