The website uses cookies to provide personalized services at the highest level, including statistical services and to adapt the content to individual preferences of users. Saving cookies can be turned off in your browser settings.
OK
[zamknij]     

LOCTITE 424 - 50g (cyanoacrylate adhesive (instant), for plastics and rubbers, colorless/transparent)

LOCTITE 424 - 50g (cyanoacrylate adhesive (instant), for plastics and rubbers, colorless/transparent) (IDH.246564)

Product description:
LOCTITE 424 provides enhanced performance on EPDM and other elastomers. This product is not recommended for use in pure oxygenand/or oxygen rich systems and should not be selected as a sealant for chlorine or other strong oxidizing materials. Further information about the product: biuro@woronko-kleje.pl

Steps to achieve the best adhesive results:
1. For best performance bond surfaces should be clean and free from grease. Use LOCTITE SF 7063.
2. This product performs best in thin bond gaps (0,05 mm).
3. Excess adhesive can be dissolved with Loctite cleanup solvents, nitromethane or acetone.

Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.
Optimal Storage: 2 °C to 8 °C. Storage below 2 °C or greater than 8 °C can adversely affect product properties.
Material removed from containers may be contaminated during use. Do not return product to the original container.
Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.

Parameters:
Tensile shear strength, ASTM D1002, DIN 53283 :
  • Steel : 18 to 26 N/mm²
  • Aluminum : 11 to 19 N/mm²
  • Zinc dichromate : 6 to 14 N/mm²
  • ABS : 6 to 20 N/mm²
  • PCV : 6 to 20 N/mm²
  • Polycarbonate : 5 to 20 N/mm²
  • Phenolic : 5 to 15 N/mm²
  • Neoprene : 5 to 15 N/mm²
  • Nitrile rubber : 5 to 15 N/mm²

Tensile strength, ASTM D2095, DIN 53288, N/mm² :
  • Steel : 12 to 25 N/mm²
  • Buna N Rubber : 5 to 15 N/mm²

Peel strength, ASTM D1876, DIN 53282, N/mm²:
  • Steel (degreased) : < 0,5 N/mm²

Full technical information can be found in the technical data sheet.

Assortment