The website uses cookies to provide personalized services at the highest level, including statistical services and to adapt the content to individual preferences of users. Saving cookies can be turned off in your browser settings.
OK
[zamknij]     

LOCTITE SF INI.5 - 35ml (activator for Loctite F 247 adhesive)

No.

IDH.1293550

LOCTITE SF INI.5 - 35ml (activator for Loctite F 247 adhesive)

LOCTITE SF INI.5 - 35ml (activator for Loctite F 247 adhesive) (IDH.1293550)

Product description:
LOCTITE SF INI5 is designed to initiate the cure of Loctite toughened acrylic adhesives Loctite F241 and Loctite F246. Fixture time and cure speed achieved as a result of using LOCTITE SF INI5 depend on the adhesive used, the substrate bonded, surface cleanliness and whether one or two surface activation is used. Further information about the product: biuro@woronko-kleje.pl

Directions for use:
1. Most surfaces may be bonded "as received" but contamination such as loose oxide layers or excessive oil may affect cure speed and bond strength. Cleaning is recommended if maximum strength is required.
2. Brush on the initiator to one of the mating surfaces to be bonded. The use of excess initiator will reduce the bond strength. Apply adhesive to other surface.
3. For large gaps (>0.4 mm) or where maximum cure speed is required then treatment of both surfaces is recommended.
4. The initiator will not dry and will remain active for up to 30 minutes. Bond assembly should be completed within this time.
5. Where adhesive is applied onto an activated surface, assembly should be completed as quickly as possible (within 15 seconds).
6. Secure the assembly and await fixturing before any further handling.

Storage:
Store product in the unopened container in a dry location. Material removed from containers may be contaminated during use. Do not return liquid to original container. Storage information may be indicated on the product container labeling. Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties. Henkel cannot assume responsibility for product which has been contaminated or stored under conditions other than those recommended.

Parameters:
  • Specific Gravity at 25 °C : 1.0
  • Viscosity at 25°C, mPa·s (cP) : ≤60
  • Fixture Time, ISO 4587, seconds:
    -Steel (grit blasted) using LOCTITE F246 single side activation : ≤45
  • Lap Shear Strength, ISO 4587:
    -Aluminum (Gritblasted), using LOCTITE F246 N/mm² : >10

    Full technical information can be found in the technical data sheet.
  • Assortment