The website uses cookies to provide personalized services at the highest level, including statistical services and to adapt the content to individual preferences of users. Saving cookies can be turned off in your browser settings.
OK
[zamknij]     

LOCTITE SF 737 - 120ml (activator for acrylic adhesives)

No.

IDH.195704

LOCTITE SF 737 - 120ml (activator for acrylic adhesives)

LOCTITE SF 737 - 120ml (activator for acrylic adhesives) (IDH.195704)

Product description:
LOCTITE SF 737 is designed to initiate the cure of Loctite toughened acrylic adhesives. Fixture time and cure speed achieved as a result of using LOCTITE SF 737 depend on the adhesive used, the substrate bonded, surface cleanliness and whether one or two surface activation is used. Further information about the product: biuro@woronko-kleje.pl

Directions for use:
1. Most surfaces may be bonded "as received" but contamination such as loose oxide layers or excessive oil may affect cure speed and bond strength. Cleaning is recommended if maximum strength is required. You can use LOCTITE SF 7063.
2. Brush on the activator to one of the mating surfaces to be bonded. Apply adhesive to other surface.
3. For large gaps (>0.4 mm) or where maximum cure speed is required then treatment of both surfaces is recommended.
4. The activator will not dry and will remain active for up to 6 hours. Bond assembly should be completed within this time.
5. Where adhesive is applied onto an activated surface, assembly should be completed as quickly as possible (within 15 seconds).
6. Secure the assembly and await fixturing before any further handling.

Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties. Material removed from containers may be contaminated during use. Do not return product to the original container. Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.

Parameters:
  • Chemical type: organic accelerator
  • Solvent: none
  • Color: dark amber
  • Specific gravity, 25°C: 0,98
  • Viscosity, 20°C, mPa*s: 50 to 100
  • Flash point (COC), °C: >100
  • Shelf life at 20 ° C, months: 12
  • Toxicity: low
  • Pot life after application, hours: 6

Full technical information can be found in the technical data sheet.

Assortment