The website uses cookies to provide personalized services at the highest level, including statistical services and to adapt the content to individual preferences of users. Saving cookies can be turned off in your browser settings.
OK
[zamknij]     
przykład użycia
Product description:
LOCTITE 603 is designed for the bonding of cylindrical fitting parts, particularly where consistently clean surfaces cannot be assured. The product cures when confined in the absence of air between close fitting metal surfaces and prevents loosening and leakage from shock and vibration. Typical applications include retaining roller bearings or oil impregnated bushings into housings. Further information on the product can be obtained from your local technical department: biuro@woronko-loctite.pl


Steps to achieve the best adhesive results:
FOR ASSEMBLY:
1. For best results, clean all surfaces (external and internal) with a LOCTITE SF 7063 cleaning solvent and allow to dry.
2. If the material is an inactive metal or the cure speed is too slow, spray with activator LOCTITE SF 7471 or LOCTITE SF 7649 and allow to dry.
3. For Slip Fitted Assemblies, apply adhesive around the leading edge of the pin and the inside of the collar and use a rotating motion during assembly to ensure good coverage.
4. For Press Fitted Assemblies, apply adhesive thoroughly to both bond surfaces and assemble at high press on rates.
5. For Shrink Fitted Assemblies the adhesive should be coated onto the pin, the collar should then be heated to create sufficient clearance for free assembly.
6. Parts should not be disturbed until sufficient handling strength is achieved.

FOR DISASSEMBLY:
7. Apply localized heat to the assembly to approximately 250 °C. Disassemble while hot.

FOR CLEAN UP:
1. Cured product can be removed with a combination of soaking in solvent LOCTITE SF 7200 and mechanical abrasion such as a wire brush.

Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during use. Do not return product to the original container.
Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.

Parameters:
  • Shear strength: 26 N/mm²
  • Time to get full strength (22 °C):
    -Steel: 6 hours
    -Zinc dichromate: 7 hours
    -Aluminum : 72 hours
  • Time to obtain initial strength (22 °C):
    -Steel : 10 minutes
    -Zinc dichromate : 50 minutes
    -Aluminum : 25 minutes
  • Working temperature : from -55 °C to +150 °C
  • Color : green


Full technical information can be found in the technical data sheet.

Assortment