The website uses cookies to provide personalized services at the highest level, including statistical services and to adapt the content to individual preferences of users. Saving cookies can be turned off in your browser settings.

Loctite 510-250ml (metal flange sealant)

przykład użycia
Product description:
LOCTITE 510 cures when confined in the absence of air between close fitting metal surfaces. This product is a general gasketing product suitable for hand dispensing or screen printing. Further information on the product can be obtained from your local technical department:

Steps to achieve the best adhesive results:
1. For best performance bond surfaces should be clean and free from grease. You can use degreaser LOCTITE SF 7063
2. The product is designed for close fitting flanged parts with gaps up to 0,25 mm ( in).
3. Apply manually as a continuous bead or by screen printing to one surface of the flanges.
4. Low pressures (<0,05 MPa, psi) may be used when testing to confirm a complete seal immediately after assembly and before curing.
5. Flanges should be tightened as soon as possible after assembly to avoid shimming.

Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during use. Do not return product to the original container.
Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.

  • Shear strength on steel: 7,5 N/mm²
  • Time to get full strength at the gap 0,05 mm (22 °C):
    -Steel : 24 hours
    -Aluminum : 72 hours
  • Time to obtain initial strength (22 °C):
    -Steel : 25 min
    -Aluminum : 45 min
  • Working temperature : from -55 °C to +200 °C
  • Color : red

Full technical information can be found in the technical data sheet.