The website uses cookies to provide personalized services at the highest level, including statistical services and to adapt the content to individual preferences of users. Saving cookies can be turned off in your browser settings.
OK
[zamknij]     

LOCTITE SI 5980 - 100ml (oil-resistant, black, olkoxy-silicone based flange seal

LOCTITE SI 5980 - 100ml (oil-resistant, black, olkoxy-silicone based flange seal (IDH.2327036)

Product description:
LOCTITE SI 5980 has been designed specifically for gasketing applications. It withstands on line, low pressure tests carried out before product begins to cure. Typical applications include stamped sheet metal covers (timing covers and oil sumps) where good oil resistance and the ability to withstand high joint-movement is required. Further information about the product: biuro@woronko-kleje.pl

Steps to achieve the best adhesive results:
1. For best performance bond surfaces should be clean and free from grease. Use LOCTITE SF 7063.
2. Moisture curing begins immediately after the product is exposed to the atmosphere, therefore parts to be assembled should be mated within a few minutes after the product is dispensed.
3. The bond should be allowed to cure (e.g. seven days), before subjecting to heavy service loads.
4. Excess material can be easily wiped away with non-polar solvents.

Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties. Material removed from containers may be contaminated during use. Do not return product to the original container. Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.

Parameters:
  • Sealant for flexible flange connections
  • Excellent resistance to glycol and oil
  • Color: black
  • Perfect for large gaps. It does not contain hazardous substances.
  • Shore Hardness, ISO 868, Durometr A : 27 Shore
  • Volume shrinkage, ISO 1675, % : 3,0
  • Linear contraction, ISO 1675, % : 1,0
  • Elongation at break, ISO 37, % : 290
  • Tensile strength , ISO 37 N/mm² : 1,6
  • Tensile modulus, ISO 37 N/mm² : 1,0


Full technical information can be found in the technical data sheet.

Assortment