The website uses cookies to provide personalized services at the highest level, including statistical services and to adapt the content to individual preferences of users. Saving cookies can be turned off in your browser settings.
OK
[zamknij]     

LOCTITE SI 5660 - 100 ml (gray, silicone flange sealant)

LOCTITE SI 5660 - 100 ml (gray, silicone flange sealant) (IDH.2326228)

Product description:
LOCTITE SI 5660 is a moisture curing silicone. The thixotropic nature of LOCTITE SI 5660 reduces the migration of liquid product after application to the substrate. It has been designed specially for gasketing applications where good resistance against oils and coolants is required. Typical applications include transmissions and cast metal housings. Further information about the product: biuro@woronko-kleje.pl

Steps to achieve the best adhesive results:
1. For best performance bond surfaces should be clean and free from grease. Use LOCTITE SF 7063.
2. Moisture curing begins immediately after the product is exposed to the atmosphere, therefore parts to be assembled should be mated within a few minutes after the product is dispensed.
3. The bond should be allowed to cure (e.g. seven days), before subjecting to heavy service loads.
4. Excess material can be easily wiped away with non-polar solvents.
5. For full automatic applications a volumetric dispensing system is recommended

Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during use. Do not return product to the original container.
Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.

Parameters:
  • Chemical type : silicon
  • Adventages : Non-corrosive
  • Cured for 7 days at 25 °C / 50% RH:
    - Shore Hardness, ISO 868, durometr A : 45 do 75
    -Linear Shrinkage, % : 1,13
    -Coefficient of Thermal Conductivity ISO 8302, W/(m·K) : 0,63
    -Tensile strength , ISO 37 N/mm² : from 2,4 to 3,8
    -Elongation at break, ISO 37, % : ≥100


Full technical information can be found in the technical data sheet.

Assortment