The website uses cookies to provide personalized services at the highest level, including statistical services and to adapt the content to individual preferences of users. Saving cookies can be turned off in your browser settings.
OK
[zamknij]     

LOCTITE SI 5075 - 2,5cm x 4,27m (silicone insulating sealing tape, red)

LOCTITE SI 5075 - 2,5cm x 4,27m (silicone insulating sealing tape, red) (IDH.1684617)

przykład użycia
Product description:
LOCTITE SI 5075 is a self-fusing, silicone rubber wrap that is recommended for reliable, temporary repairs on a variety of substrates. LOCTITE SI 5075 does not bond to the substrate so it must be used as a wrap due to the self-fusing properties of the tape. Typical applications includes flexible hose repair, pipe repair, tool handle wrap, and electrical insulative wrap. Further information about the product: biuro@woronko-kleje.pl

Steps to achieve the best adhesive results:
1. Separate LOCTITE SI 5075 from the liner.
2. Peel away enough silicone wrap to complete the repair.
3. Press one end onto the surface and begin to wrap.
4. Stretch the silicone wrap tightly while wrapping over the repair area.
5. Wrap the repair area with a two-thirds overlap for a proper seal.
6. Finish wrapping by overlapping the silicone wrap with a previous layer.

Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during use. Do not return product to the original container.
HenkelCorporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated. If additional information is required, please contact your local Technical Service Center or Customer Service Representative.

Parameters:
  • Working temperature: from - 54 °C to 260 °C
  • Hardness Shore A : 50
  • Color : black, red
  • Tensile strength : to 5 MPa (700 PSI)
  • Surface resistivity, IEC 60093, Ω: 74,3*10^15
  • Tear strength, ISO 34-1 N/mm² : 0,6


Full technical information can be found in the technical sheet.

Assortment