Try to find the solution
LOCTITE SF 7023 - 400ml (power supply cleaner)
No.
IDH.1005879
Price
LOCTITE SF 7023 - 400ml (power supply cleaner)
Product description:
LOCTITE® SF 7023™ is a high quality product based on high power solvents. This product quickly dissolves deposits ofresin, oil and varnish. LOCTITE® SF 7023™ is used on air intakes, carburetor parts, valves, actuators, EGR valves, injectors, idling motors, throttle motors, air mass meters, and plastic parts. The product leaves no film that can cause jamming of parts. Further information about the product: biuro@woronko-kleje.pl
Directions for use:
1. Shake the product thoroughly before use.
2. Spray the external surfaces of the carburetor and wipe clean with a dry cloth.
3. Start the engine and run for several minutes until hot.
4. Stop engine, remove air filter from carburetor and spray for approximately 10 seconds into the air intake opening.
5. Leave to soak for 3 minutes.
6. Start the engine and spray for a further 30 seconds into air intake.
7. Allow the engine to run with occasional revving, until it runs smoothly.
NOTE: Wash off immediately if sprayed on car finish. Can cause wax or paint streaking.
Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties. Material removed from containers may be contaminated during use. Do not return product to the original container. Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:Chemical type : hydrocarbons and alcohol Appearance : transparent liquid Odor : solvent Dispense method : spray Propellant : propane Density at 20 °C, g/ml : 0.8 to 0.81
Further information can be found in the technical data sheet
LOCTITE® SF 7023™ is a high quality product based on high power solvents. This product quickly dissolves deposits ofresin, oil and varnish. LOCTITE® SF 7023™ is used on air intakes, carburetor parts, valves, actuators, EGR valves, injectors, idling motors, throttle motors, air mass meters, and plastic parts. The product leaves no film that can cause jamming of parts. Further information about the product: biuro@woronko-kleje.pl
Directions for use:
1. Shake the product thoroughly before use.
2. Spray the external surfaces of the carburetor and wipe clean with a dry cloth.
3. Start the engine and run for several minutes until hot.
4. Stop engine, remove air filter from carburetor and spray for approximately 10 seconds into the air intake opening.
5. Leave to soak for 3 minutes.
6. Start the engine and spray for a further 30 seconds into air intake.
7. Allow the engine to run with occasional revving, until it runs smoothly.
NOTE: Wash off immediately if sprayed on car finish. Can cause wax or paint streaking.
Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties. Material removed from containers may be contaminated during use. Do not return product to the original container. Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:
Further information can be found in the technical data sheet
