The website uses cookies to provide personalized services at the highest level, including statistical services and to adapt the content to individual preferences of users. Saving cookies can be turned off in your browser settings.
OK
[zamknij]     

LOCTITE PC 7234 - 1kg (epoxy resin with ceramic filler, smooth, up to 205 °C)

No.

IDH.2049551

LOCTITE PC 7234 - 1kg (epoxy resin with ceramic filler, smooth, up to 205 °C)

LOCTITE PC 7234 - 1kg (epoxy resin with ceramic filler, smooth, up to 205 °C) (IDH.2049551)

przykład użycia
Product description:
LOCTITE PC 7234™ is an ultra smooth, ceramic reinforced epoxy that provides a high gloss, low friction coating designed to protect against turbulence and abrasion under typical dry service temperatures of -29 to 288 °C. Used by itself, LOCTITE PC 7234 is recommended for sealing and protecting equipment from corrosion and wear. It also works as a top coat over Loctite Nordbak Wearing Compounds for applications requiring surface rebuilding and lasting protection. Typical applications include providing a smooth, protective abrasion resistant coating, repairing heat exchangers and condensers, lining tanks and chutes, resurfacing and repairing rudders and pintel housings, and repairing cooling pump impellers and butterfly valves. Further information about the product: biuro@woronko-kleje.pl

Steps to achieve the best adhesive results:
Surface Preparation
Proper surface preparation is critical to the long-term performance of this product. The exact requirements vary with the severity of the application, expected service life, and initial substrate conditions.
1. Clean, dry and abrade application surface. You can use LOCTITE SF 7063. The more thorough the degree of surface preparation the better the performance of the application. If possible, it is recommended that the surface be grit blasted to a Near White Metal (SSPC-SP10/NACE No. 2) Standard. For less severe applications roughening the surface with hand tools is suitable.
2. Solvent cleaning with a residue-free solvent is recommended as the final step to aid in adhesion.

Mixing
1. Material temperature should be between 20 to 30 °C.
2. Add hardener contents to resin. Mix material vigorously until uniform in color. Be sure to mix along the bottom and sides of mixing container. Mix three to five minutes.

Application Method
1. Apply fully mixed material to the prepared surface .
2. Cure time is 8 hours followed by a 3 hour post-cure at 150°C

Storage:
Store product in the unopened container in a dry location. Material removed from containers may be contaminated during use. Do not return liquid to original container. Storage information may be indicated on the product container labeling. Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties. Henkel cannot assume responsibility for product which has been contaminated or stored under conditions other than those recommended.

Parameters:
  • Working life, minutes : 30
  • Working temperature : -30 °C to 205 °C
  • Color : grey liquid
  • Shore Hardness, ISO 868, Shore D : 88
  • Compressive Strength, ISO 604 N/mm² : 102
  • Tensile Strength, ISO 527-2 N/mm² : 37
  • Tensile Modulus, ISO 527-2 N/mm² : 5,340

    Full technical information can be found in the technical data sheet.
  • Assortment