Try to find the solution
LOCTITE LB 8151 - 150ml (aluminum based anti-seize lubricant, up to 900 °C)
No.
IDH.342092
LOCTITE LB 8151 - 150ml (aluminum based anti-seize lubricant, up to 900 °C)
Product description:
LOCTITE 8151 is an anti-seize spray for threaded connections exposed to high temperatures to prevent seizing and corrosion. This product prevents seizing or jamming in joints exposed to high temperatures (e.g. exhausts of combustion engines and fittings or oil and gas burners). This product is typically used in applications with an operating range of -30 °C to +900 °C. Further information about the product: biuro@woronko-kleje.pl
Directions for use:
1. For best performance part surfaces should be clean and free of grease.
2. Cleaner LOCTITE SF 7063 may be used to remove oxides and lubricant residues.
3. Shake the product thoroughly before use.
4. Spray on to clean parts, where possible, from a distance of approximately 15 to 20 cm to give a uniform film.
Storage:
The product is classified as HIGHLY FLAMMABLE and must be stored in an appropriate manner in compliance with relevant regulations. Do not store near oxidizing agents or combustible materials. Store product in the unopened container in a dry location. Storage information may also be indicated on the product container labelling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties.
Henkel cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:
Full technical information can be found in the product technical sheet.
LOCTITE 8151 is an anti-seize spray for threaded connections exposed to high temperatures to prevent seizing and corrosion. This product prevents seizing or jamming in joints exposed to high temperatures (e.g. exhausts of combustion engines and fittings or oil and gas burners). This product is typically used in applications with an operating range of -30 °C to +900 °C. Further information about the product: biuro@woronko-kleje.pl
Directions for use:
1. For best performance part surfaces should be clean and free of grease.
2. Cleaner LOCTITE SF 7063 may be used to remove oxides and lubricant residues.
3. Shake the product thoroughly before use.
4. Spray on to clean parts, where possible, from a distance of approximately 15 to 20 cm to give a uniform film.
Storage:
The product is classified as HIGHLY FLAMMABLE and must be stored in an appropriate manner in compliance with relevant regulations. Do not store near oxidizing agents or combustible materials. Store product in the unopened container in a dry location. Storage information may also be indicated on the product container labelling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties.
Henkel cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:
- Chemical composition : mineral oil, aluminum, graphite
- Color : grey
- Smell : weak
- Density at 20 °C, g / ml: 0,7
- NLGI consistency class: 0
- Flash point, ° C : not applicable
- Working temperature : -30 °C do +900 °C
Full technical information can be found in the product technical sheet.
