The website uses cookies to provide personalized services at the highest level, including statistical services and to adapt the content to individual preferences of users. Saving cookies can be turned off in your browser settings.
OK
[zamknij]     

LOCTITE LB 8030 - 250ml (threading, drilling and cutting oil)

LOCTITE LB 8030 - 250ml (threading, drilling and cutting oil) (IDH.1324500)

Product description:
LOCTITE LB 8030 is a multi-purpose cutting oil used to facilitate machining operations. This product permits greater cutting speed with improved surface finish and increased tool life. It is a lubricant for wear prevention during drilling and for use in general machining operations. Suitable for use on steel and stainless steel. However it should not be used on aluminum, titanius and copper alloy surfaces where appearance is important. This product is typically used in applications with an operating range of -20 °C to +160 °C. Further information about the product: biuro@woronko-kleje.pl

Directions for use:
1. Apply LOCTITE LB 8030 to tool prior and during cutting operation.

Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during use. Do not return product to the original container.
Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.

Parameters:
  • Chemical compound: mineral oil with EP additives
  • Appearance: dark yellow
  • Density at 20 °C, g/ml : 0,895
  • Viscosity at 40°C, cSt : 170
  • Temperature of solidification, °C : <-30
  • Maximum temperature, °C : 200

Full technical information can be found in the technical data sheet.

Assortment