The website uses cookies to provide personalized services at the highest level, including statistical services and to adapt the content to individual preferences of users. Saving cookies can be turned off in your browser settings.
OK
[zamknij]     

LOCTITE FREKOTE FRP- NC - 5L (release agent)

LOCTITE FREKOTE FRP- NC - 5L (release agent) (IDH.381079)

Product description:
Loctite Frekote FRP-NC is a unique release interface specifically formulated for reinforced polyester gel coats (and other associated resin systems). This semi-permanent release coating chemically bonds to the mold surface, forming a micro thin release film. Loctite Frekote FRP-NC provides a high gloss finish and minimal mold build-up thus eliminating buffing and cleaning between applications. Multiple releases per application also contributes to major time savings. Further information about the product: biuro@woronko-kleje.pl

Directions for use:
1. Apply with a clean lint free 100% cotton cloth. Soak cloth with Loctite® Frekote FRP-NC until it is wet, but not dripping.
2. Wipe a smooth, wet film over a 2' x 2' to 2' x 3' area of the mold surface. Do not over apply.
3. Wait 10-20 seconds at 21ºC (70°F) after application. Gently wipe dry with, a second clean dry, cotton cloth.NOTE: Changes in temperature will affect solvent dry time. At temperatures below 18ºC (65°F), waiting time between wiping on and drying off will be longer than 20 seconds. A general guideline is to wait until the edges of the wiped area begin to creep inwards indicating that evaporation has progressed sufficiently. Light hand pressure is all that is needed. No hard rubbing is required. Change cloth frequently to ensure proper drying of the mold.
4. Coat entire mold surface in this manner slightly overlapping the last area coated. Apply a maximum of 6 coats initially. A couple of extra coats can be applied in high wear areas for added slip. Allow 15-20 minutes cure time at room temperature between coats and after the final coat.
5. Commence molding. A single coat of Loctite Frekote FRP-NC should be applied after each release for the first two to three releases. This helps to condition the mold, which in turn offers multiple releases on future production.

Parameters:
  • Appearance : clear liquid
  • Odor : hydrocarbon
  • Solvents : aliphatic hydrocarbon, dibutyl ether
  • Specific gravity : 0.770 +/- 0.010
  • Flash Point : 28 °C Tag Closed Cup.
  • Shelf Life : one year from date of manufacture
  • Application temperature: 13 ºC to 40 ºC

    Full technical information can be found in the technical data sheet
  • Assortment