Try to find the solution
LOCTITE FREKOTE 915 WB - 9,8kg (mold sealant)
No.
IDH.846863
Price
LOCTITE FREKOTE 915 WB - 9,8kg (mold sealant)
Product description:
LOCTITE FREKOTE 915-WB is a water-based cleaner developed for removing residue from mold surfaces. The high-grade surfactants and emulsifiers in combination with fine abrasives give excellent results without dulling the mold surface. Further information about the product: biuro@woronko-kleje.pl
Directions for use:
1. Shake LOCTITE FREKOTE 915-WB before use. Application temperature range is 20°C - 40°C.
2. Apply product to mold surfaces with a cotton cloth or paper towel. Cloth should be wet with product but not dripping. Allow the cleaner to begin softening residue for approximately 5 minutes. NOTE: Damp cleaner decreases removal labor.
3. Rub or buff mold surface until residue is removed.
4. Rinse mold with water or other mild solvent.
5. NOTE: A simple test to assess mold cleanliness is the use of masking tape. A coated surface will allow easy release of masking tape, where as a wax free surface will allow good adhesion of masking tape. This test can also be used to determine the effectiveness of Frekote Release Interfaces. A good interface will prevent any significant degree of tape adhesion.
Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during use. Do not return product to the original container.
Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:
Appearance : beige pasty liquid Chemical type : water based emulsion Cure : room temperature cure Density at 25 °C, g/ml : 0.97 to 0.99 Odor : mild Citrus
Full technical information can be found in the technical data sheet
LOCTITE FREKOTE 915-WB is a water-based cleaner developed for removing residue from mold surfaces. The high-grade surfactants and emulsifiers in combination with fine abrasives give excellent results without dulling the mold surface. Further information about the product: biuro@woronko-kleje.pl
Directions for use:
1. Shake LOCTITE FREKOTE 915-WB before use. Application temperature range is 20°C - 40°C.
2. Apply product to mold surfaces with a cotton cloth or paper towel. Cloth should be wet with product but not dripping. Allow the cleaner to begin softening residue for approximately 5 minutes. NOTE: Damp cleaner decreases removal labor.
3. Rub or buff mold surface until residue is removed.
4. Rinse mold with water or other mild solvent.
5. NOTE: A simple test to assess mold cleanliness is the use of masking tape. A coated surface will allow easy release of masking tape, where as a wax free surface will allow good adhesion of masking tape. This test can also be used to determine the effectiveness of Frekote Release Interfaces. A good interface will prevent any significant degree of tape adhesion.
Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during use. Do not return product to the original container.
Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:
Full technical information can be found in the technical data sheet
