The website uses cookies to provide personalized services at the highest level, including statistical services and to adapt the content to individual preferences of users. Saving cookies can be turned off in your browser settings.
OK
[zamknij]     
przykład użycia
Product description:
LOCTITE 3090 is a two component, fast curing, gap filling adhesive with excellent bonding characteristics to a variety of substrates including plastics, rubbers and metals. LOCTITE 3090 is designed for the assembly of parts with varying or undefined bond gaps up to 5 mm (0.2 in), or for applications where complete cure of excess adhesive is a requirement. The gel consistency prevents adhesive flow even on vertical surfaces. LOCTITE 3090 is also suited for bonding porous materials such as wood, paper, leather and fabric. Further information about the product: biuro@woronko-kleje.pl

Steps to achieve the best adhesive results:
1. Bond areas should be clean and free from grease. Clean all surfaces with a LOCTITE SF 7063 cleaning solvent and allow to dry.
2. To use, Part A and Part B must be blended. Product can be applied directly from dual cartridge by dispensingthrough the mixer head supplied. Discard the first 1 to 2 cm of bead dispensed.
3. Apply mixed adhesive to one of the bond surfaces. Do not use items like tissue or a brush to spread the adhesive. Assemble the parts within a few seconds. The parts should be accurately located, as the short fixture time leaves little opportunity for adjustment.
4. Bonds should be held fixed or clamped until adhesive has fixtured.
5. Product should be allowed to develop full strength before subjecting to any service loads (typically 24 hours after assembly).

Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.
Optimal Storage: 2 °C to 8 °C. Storage below 2 °C or greater than 8 °C can adversely affect product properties.
Material removed from containers may be contaminated during use. Do not return product to the original container.
Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.

Parameters:
    Cured for 24 hours ( 22 °C ) :
  • Shear strength, ISO 4587:
    -Steel (poddana obróbce strumieniowo ściernej), N/mm² : 21
    -Aluminum etched, N/mm² : 9
    -Zinc dichromate, N/mm² : 9
    -ABS, N/mm² : 8
    -PVC, N/mm² : 8
    -Phenolic, N/mm² : 2
    - Polycarbonate, N/mm² : 12
    -GRP, N/mm² : 4
    -Nitrile rubber, N/mm² : 1
    -Wood (Oak), N/mm² : 11
    -Wood (Chipboard), N/mm² : 1,5
    -Leather, N/mm² : 2

    Full technical information can be found in the technical data sheet.

Assortment