The website uses cookies to provide personalized services at the highest level, including statistical services and to adapt the content to individual preferences of users. Saving cookies can be turned off in your browser settings.
OK
[zamknij]     

LOCTITE 97144 (rotorspray do nakładania produktów Loctite na wewnętrzne cylindryczne powierzchnie przedmiotów obrabianych / rotorspray for applying Loctite products to the interior cylindrical surfaces of workpieces)

No.

IDH.527593

LOCTITE 97144 (rotorspray do nakładania produktów Loctite na wewnętrzne cylindryczne powierzchnie przedmiotów obrabianych / rotorspray for applying Loctite products to the interior cylindrical surfaces of workpieces)

LOCTITE 97144 (rotorspray do nakładania produktów Loctite na wewnętrzne cylindryczne powierzchnie przedmiotów obrabianych / rotorspray for applying Loctite products to the interior cylindrical surfaces of workpieces) (IDH.527593)

Product description:
With the Rotorsprays 97144 and 97145 (with integrated safety switch), LOCTITE Products can be applied to the interior cylindrical surfaces of workpieces. The Rotorsprays are operated in combination with dispensing valves 97134 or 97135/97136. The Positive Displacement Pump 983330 can be used with the Rotorsprays, too. The simultaneous control of these units requires the use of a PLC. It is possible to use also LOCTITE Controller 97123 with integrated Valve Module, Controller 97103 with a external Solenoid Valve Module 97204 or a corresponding controller for the Positive Displacement Pump. Only low viscosity anaerobic adhesives can be applied with the Rotorsprays 97144/97145. The Rotorspray 97145 is NRTL certified. To meet the relevant safety requirements for the North American Market the Rotorspray 97145 was tested according to the UL 745-1:1995. The test is done by TÜV PRODUCT SERVICE, an accredited laboratory.

Directions for use:
The Rotorspray 97144 or 97145 is clamped in a fixture. The dispensing valve is clamped in the holder of the rotorspray so that the tip of the flexible dispensing needle is directed to the inside of the wetting holes on the rotor disk . The PLC, LOCTITE Controller 97103/97204 or the Controller 97123 must control:
– The switching on of the rotorspray.
– The preselected dispensing after the rated rotor speed is reached time.
– The switching off of the rotorspray.

As long as the dispensing valve is open, the product is dispensed through the wetting holes by centrifugal force and uniformly distributed onto the cylindrical inner surface of the part. In conjunction with an advancing slide, the dispensing is triggered by reaching the end of the advancing movement. The head of the rotorspray has a longitudinal play of 5 mm. Within this distance, unintentional contact with an obstacle can be compensated without the rotor disk or the drive assembly and its shaft being damaged. Furthermore the drive assembly is designed that in case the product flows back, the drive assembly and the rotor housing cannot bond together. With longitudinal play and the special design of the drive assembly a perfect function is guaranteed.

Parameters:
  • Rated Revolution: 8,000 rpm
  • Ambient Operating temperature : +10°C to +40°C
  • Rated starting-up current : 0.8 A
  • Storage temperature : -10°C to +60°C
  • Weight : 0.530 kg
  • Assortment