The website uses cookies to provide personalized services at the highest level, including statistical services and to adapt the content to individual preferences of users. Saving cookies can be turned off in your browser settings.
OK
[zamknij]     
przykład użycia
Product description:
LOCTITE SI 5331 is recommended for use on plastic pipe threaded fittings carrying hot or cold water. This product cures at ambient temperatures under the influence of atmospheric moisture to form a low strength flexible seal against hot and cold water. Further information about the product: biuro@woronko-kleje.pl




Steps to achieve the best adhesive results:
1. Apply the product to the threaded parts (these may be to,"as received" parts or parts cleaned with a damp cloth or paper towel).
2. Product should be applied to both male and female threads and then worked into the threads to ensure good wetting.
3. For potable water systems, allow product to cure for 96 hours at 20 to 23°C prior to use.

Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during use. Do not return product to the original container.
Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.

Parameters:
  • Strength: low
  • Viscosity: medium
  • Breakaway Torque ( after 72 hours at 22 °C ):
    -steel nuts and bolts (M10) [N·m] : 1,5
  • Prevail Torque ( after 72 hours at 22 °C ):
    -steel nuts and bolts (M10) [N·m] : 0,5
  • Breakloose Torque, Pre-torqued to 5 N·m: ( after 72 hours at 22 °C ):
    -steel nuts and bolts (M10) [N·m]: 4,5


Full information can be found in the technical data sheet.

Assortment