LOCTITE LB 8021 - 400ml (silicone oil) spray
No.
IDH.2385331
Product description:
LOCTITE LB 8021 is a general purpose, low viscosity silicone oil used for lubricating metal and non-metal surfaces (e.g. guides, conveyors, cutting knives and plastic components). It may also be used as a release agent in moulds, etc. This product is typically used in applications with an operating range of -30 °C to +150 °C (continuous) and -50 °C to +250 °C (peaks) after complete evaporation of solvents. Further information about the product: biuro@woronko-kleje.pl
Directions for use:
1. Shake can thoroughly before use. Spray on to clean parts, where possible.
2. LOCTITE SF 7063 may be used to remove old oil residues, but when they cannot be used, it is important to check the compatibility of old oils with the new lubricant.
3. This product should not be used on parts which are likely to be painted.
Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during use.
Do not return product to the original container.
Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:
Full technical information can be found in the technical data sheet.
LOCTITE LB 8021 is a general purpose, low viscosity silicone oil used for lubricating metal and non-metal surfaces (e.g. guides, conveyors, cutting knives and plastic components). It may also be used as a release agent in moulds, etc. This product is typically used in applications with an operating range of -30 °C to +150 °C (continuous) and -50 °C to +250 °C (peaks) after complete evaporation of solvents. Further information about the product: biuro@woronko-kleje.pl
Directions for use:
1. Shake can thoroughly before use. Spray on to clean parts, where possible.
2. LOCTITE SF 7063 may be used to remove old oil residues, but when they cannot be used, it is important to check the compatibility of old oils with the new lubricant.
3. This product should not be used on parts which are likely to be painted.
Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during use.
Do not return product to the original container.
Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:
- Chemical composition : silicone oil
- Color : colorless
- Odor : odorless
- Density (25 °C), g/ml : 0,7
- Viscosity (20 °C), mm²/s : 10
- Solidification temperature of the base oil, °C : -65
- Working temperature range (after complete evaporation of the solvent): -50 °C to +200 °C
Full technical information can be found in the technical data sheet.