LOCTITE ETCH AGENT - 88,7ml EN/DE (Loctite PC 7352 primer)
No.
IDH.2243015
Associated products:
LOCTITE ETCH AGENT - 88,7ml EN/DE (Loctite PC 7352 primer)
Associated products:
Product description:
LOCTITE Etching Agent etches surfaces for better adhesion of urethanes.
Product Features:
Enhances bonding of urethanes
GENERAL INFORMATION
This product is not recommended for use in pure oxygen and/or oxygen rich systems and should not be selected as a sealant for chlorine or other strong oxidizing materials. For safe handling information on this product, consult the Safety Data Sheet (SDS). Further information about the product: biuro@woronko-kleje.pl
Directions for use:
1. Brush etch agent onto clean application surface.
2. Allow drying for 30 minutes at 25°C or 60 minutes in 10 °C.
3. NOTE: Do not use on Nitrile, PVC, or thermal plastic urethane.
Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling. Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties. Material removed from ontainers may be contaminated during use. Do not return product to the original container. Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Full technical information can be found in the technical data sheet
LOCTITE Etching Agent etches surfaces for better adhesion of urethanes.
Product Features:
Enhances bonding of urethanes
GENERAL INFORMATION
This product is not recommended for use in pure oxygen and/or oxygen rich systems and should not be selected as a sealant for chlorine or other strong oxidizing materials. For safe handling information on this product, consult the Safety Data Sheet (SDS). Further information about the product: biuro@woronko-kleje.pl
Directions for use:
1. Brush etch agent onto clean application surface.
2. Allow drying for 30 minutes at 25°C or 60 minutes in 10 °C.
3. NOTE: Do not use on Nitrile, PVC, or thermal plastic urethane.
Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling. Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties. Material removed from ontainers may be contaminated during use. Do not return product to the original container. Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Full technical information can be found in the technical data sheet
