TEROSON Bond Activator - 125ml (Activator)
No.
IDH.2683266
Associated products:
TEROSON Bond Activator - 125ml (Activator)
Associated products:
Product description:
TEROSON® BOND ACTIVATOR is a solvent based active cleaner, which contains silanes. It is free from chlorinated hydrocarbons, aromatic solvents and from isocyanates. TEROSON® BOND ACTIVATOR is used for cleaning and activating glass and ceramic coatings prior to glass bonding without black glass primer. Typical applications include the bonding of front, rear and side screens to the body of passenger-, utility-, special- and rail vehicles. Further information about the product: biuro@woronko-kleje.pl
Directions for use:
Application
TEROSON® BOND ACTIVATOR is applied with a clean cloth to the surface. After this wet application it is not allowed towipe off with a dry cloth. The adhesive can be applied after 5 minutes drying time. Drying speed is depending on environmental conditions. TEROSON® BOND ACTIVATOR is applied on glass or ceramic coating, but only in the bonding area. It is not suitable for cleaning of visible areas due to reactive ingredients that may lead to spots and stripes after drying. Contaminations in the visible areas must be removed immediately by using a pure solvent cleaner.
Storage:
Store product in the unopened container in a dry location. Storage information may also be indicated on the product container labelling. Optimal Storage: 15 to 25 °C. Storage below 5 °C or greater than 25 °C can adversely affect product properties. Material removed from containers may be contaminated during use. Do not return product to the original container. Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:Chemical type : silane containing solvent Appearance (uncured) : clear liquid Components : one-component – requires no mixing Viscosity : liquid Cure : humidity Application : surface pretreatment Environmental temperature at application : 10 to 45 °C Material application temperature : 10 to 35 °C In service temperature : -40 to 90 °C Short exposure (up to 1h) : 120 °C Specific Gravity : 0.7 Solids, % : 1.4 Drying time, minutes : 5
Further information can be found in the technical data sheet
TEROSON® BOND ACTIVATOR is a solvent based active cleaner, which contains silanes. It is free from chlorinated hydrocarbons, aromatic solvents and from isocyanates. TEROSON® BOND ACTIVATOR is used for cleaning and activating glass and ceramic coatings prior to glass bonding without black glass primer. Typical applications include the bonding of front, rear and side screens to the body of passenger-, utility-, special- and rail vehicles. Further information about the product: biuro@woronko-kleje.pl
Directions for use:
Application
TEROSON® BOND ACTIVATOR is applied with a clean cloth to the surface. After this wet application it is not allowed towipe off with a dry cloth. The adhesive can be applied after 5 minutes drying time. Drying speed is depending on environmental conditions. TEROSON® BOND ACTIVATOR is applied on glass or ceramic coating, but only in the bonding area. It is not suitable for cleaning of visible areas due to reactive ingredients that may lead to spots and stripes after drying. Contaminations in the visible areas must be removed immediately by using a pure solvent cleaner.
Storage:
Store product in the unopened container in a dry location. Storage information may also be indicated on the product container labelling. Optimal Storage: 15 to 25 °C. Storage below 5 °C or greater than 25 °C can adversely affect product properties. Material removed from containers may be contaminated during use. Do not return product to the original container. Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:
Further information can be found in the technical data sheet
