TEROSON SB 3120 - 500ml spray (chassis weight black)
No.
IDH.803863
Product description:
TEROSON SB 3120 is a solvent free, thixotropic underbody coating based on rubber and resins. After complete drying, the coating offers a permanently elastic, abrasion resistant, highly adhesive protective coating, which protects reliably against corrosion and road stone chips. The material has excellent sag-resistance and dries quickly; after complete drying the material can be painted. The dry film adheres well to cleaned underbodies, to bare metal and to painted surfaces. Further information about the product: biuro@woronko-kleje.pl
Directions for use:
The material should be at room temperature at the time of application. Shake the can well, continuing for 1 min. after theball/bearing becomes audible. Hold can vertically while spraying and apply in two three crossing patterns at a distance of about 20 to 30 cm. Abrassion resistance and corrosion protection increase with the layer of thickness. For that reason the spray application should be repeated once or twice after a short flash-off time. In order to avoid bare patches, the material should be sprayed in criss-cross fashion. Do not spray on moveable parts and those subjected to extreme heat, e.g. exhaust pipes.
Storage:
Recommended storage temperature, °C : 10 to 20 Shelf-life (in unopened original packaging), months :18 Frost-Sensitive : No
Parameters:
Colour black Odour of solvents Density approx. 1.14 g/cm³ Solids of the active ingredient approx. 55 % Sag resistance good Layer thickness dry film : (2-3 crossing patterns) : 400 to 500 µm Skin formation time : ca. 2 h Application temperature : 15 to 25 °C In service temperature range : -20 to 70 °C Short exposure (up to 1 h) : 100 °C
Full technical information can be found in the technical data sheet
TEROSON SB 3120 is a solvent free, thixotropic underbody coating based on rubber and resins. After complete drying, the coating offers a permanently elastic, abrasion resistant, highly adhesive protective coating, which protects reliably against corrosion and road stone chips. The material has excellent sag-resistance and dries quickly; after complete drying the material can be painted. The dry film adheres well to cleaned underbodies, to bare metal and to painted surfaces. Further information about the product: biuro@woronko-kleje.pl
Directions for use:
The material should be at room temperature at the time of application. Shake the can well, continuing for 1 min. after theball/bearing becomes audible. Hold can vertically while spraying and apply in two three crossing patterns at a distance of about 20 to 30 cm. Abrassion resistance and corrosion protection increase with the layer of thickness. For that reason the spray application should be repeated once or twice after a short flash-off time. In order to avoid bare patches, the material should be sprayed in criss-cross fashion. Do not spray on moveable parts and those subjected to extreme heat, e.g. exhaust pipes.
Storage:
Parameters:
Full technical information can be found in the technical data sheet