The website uses cookies to provide personalized services at the highest level, including statistical services and to adapt the content to individual preferences of users. Saving cookies can be turned off in your browser settings.
OK
[zamknij]     

LOCTITE SF 7800 - 400ml (zinc spray)

LOCTITE SF 7800 - 400ml (zinc spray) (IDH.303140)

Product description:
LOCTITE SF 7800 provides a corrosion protective coating at room temperature on ferrous metals. Typical applications include touching up metal parts after welding and to provide long-term protection of metal assemblies. It is also used to restore protection to repaired galvanized parts (e.g. crash barriers, tubes, flanges, tanks, panels, etc.). This product is typically used in applications with an operating range of -50 °C to +550 °C. Further information about the product: biuro@woronko-kleje.pl

Directions for use:
1. Shake can thoroughly before use.
2. For best results, apply to clean, dry surfaces.
3. Spray an even coat of LOCTITE SF 7800 from a distance of about 20 to 30 cm.

Storage:
The product is classified as HIGHLY FLAMMABLE and must be stored in an appropriate manner in compliance with relevant regulations. Do not store near oxidizing agents or combustible materials. Store product in the unopened container in a dry location. Storage information may also be indicated on the product container labelling. Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties. Henkel cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.

Parameters:
  • Density at 20 °C, g/ml : 0.894
  • Viscosity at 20°C, cSt : 0.6
  • Salt Spray Test, DIN 53210 (290 hours) : Ri 0
  • Pressure at 20 °C, Bar 4
  • Drying Time at 20 °C, minutes : 2 to 5
  • Delivery Rate, g/s : 1.7
  • Overpaintable , (30 µ film) at 20 °C, hours : 24

    Full technical information can be found in the technical data sheet.
  • Assortment