The website uses cookies to provide personalized services at the highest level, including statistical services and to adapt the content to individual preferences of users. Saving cookies can be turned off in your browser settings.
OK
[zamknij]     

LOCTITE PC 6315 BK big foot, 2K - 6,46kg (anti-slip resin, black)

No.

IDH.1910285

LOCTITE PC 6315 BK big foot, 2K - 6,46kg (anti-slip resin, black)

LOCTITE PC 6315 BK big foot, 2K - 6,46kg (anti-slip resin, black) (IDH.1910285)

przykład użycia
Product description:
LOCTITE Big Foot Water Based Primer/Sealer is a sealing system designed to increase the adhesion and coverage of Loctite Big Foot non-slip coatings on concrete, wood, tile and other porous substrates. LOCTITE Big Foot Water Based Primer/Sealer is designed to be used as a base coat for Loctite Big Foot non-slip coatings, except Loctite Big Foot Acrylic Pedestrian Grade. It dries quickly, ensuring good intercoat adhesion with topcoats. Typical applications include use in kitchens, hospitals, and beverage plants. This product is typically used in applications with an operating range of -29 °C to +60 °C. Further information about the product: biuro@woronko-kleje.pl

Steps to achieve the best adhesive results:
1. All surfaces to be coated should be sound, clean, dry and free of all contaminants.
2. Loose dirt and dust are best removed by a stiff bristle brush or by blowing down with dry, oil-free compressed air.
3. Oil, wax and grease should by removed by dissolving in a water-based cleaner/degreaser such as Loctite® Natural Blue Cleaner and Degreaser. Rinse thoroughly with fresh water while the dissolved solution is still wet. An alternate method is to clean with appropriate solvents such as mineral spirits as per SSPC-SP-1. It is important that the solvent be removed from the surface while still liquid and not be allowed to evaporate during the cleaning process and redeposit oil or grease on the deck. Ample solvent should be applied to the surface to completely dissolve the grease and oil. The solvent containing the dissolved grease and oil should be wiped up with clean rags before the solvent dries.
4. Depending on concentration and type, chemical contamination should be removed by detergent power washing followed by a liberal fresh water while the detergent is still wet. Allow surface to completely dry.
5. After cleaning, any remaining loose particles should be removed by brushing or blowing with dry, oil-free compressed air.

Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during use. Do not return product to the original container.
Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.

Parameters:
  • Cure Time ( 25 °C), hours : 3 to 6
  • Pot life , hours : 2
  • Recoat Time ( 21 °C), hours : 6

    Full technical information can be found in the technical data sheet
  • Assortment