TEROSON UP 250 - 759g (Body Filler)
No.
IDH.2246518
Product description:
TEROSON UP 250 is the elastic filler for all type of paintable plastic repairs. TEROSON UP 250 repairs:
● scratches
● reshaping of bumpers
● imperfections
Directions for use:
Use the amount of Body Filler according to the required repair area and mix the mass in a ratio of a golf ball size (40mL) witha 4 to 5 cm (2 to 3 %) long hardener stripe of TEROSON UP 190, using a spreader until a uniform color has been achieved. After mixing the time to apply the filler is approximately 3 minutes at 20°C. Apply the filler mixture onto the repair area in a way that the dent, scratch or hole is sufficiently filled. Thicker layers should be built up using multiple layers.Surface can be sanded after 25 to 30 minutes at room temperature. Accelerated cure, using an infrared heater (surface temperature max. 60°C) is possible after 10 minutes of the Body Filler application. Further information about the product: biuro@woronko-kleje.pl
Storage:
Frost sensitive : no Recommended storage temperature: 10 to 25 °C Shelf life : 24 months in original packaging
Parameters:
Component A:
Colour: dark grey Odour: styrene Density: approx. 1,86 g/cm³
Component B: Colour: red Odour : neutral Density : approx. 1,1 g/cm³
Mixture (Component A+B): Mixing ratio by volume : 100: 2-3 Pot life (20 °C, 50% rh) : 3 min. Grinding : possible after 25 to 30 min.
Full technical information can be found in the technical data sheet
TEROSON UP 250 is the elastic filler for all type of paintable plastic repairs. TEROSON UP 250 repairs:
● scratches
● reshaping of bumpers
● imperfections
Directions for use:
Use the amount of Body Filler according to the required repair area and mix the mass in a ratio of a golf ball size (40mL) witha 4 to 5 cm (2 to 3 %) long hardener stripe of TEROSON UP 190, using a spreader until a uniform color has been achieved. After mixing the time to apply the filler is approximately 3 minutes at 20°C. Apply the filler mixture onto the repair area in a way that the dent, scratch or hole is sufficiently filled. Thicker layers should be built up using multiple layers.Surface can be sanded after 25 to 30 minutes at room temperature. Accelerated cure, using an infrared heater (surface temperature max. 60°C) is possible after 10 minutes of the Body Filler application. Further information about the product: biuro@woronko-kleje.pl
Storage:
Parameters:
Component A:
Component B:
Mixture (Component A+B):
Full technical information can be found in the technical data sheet