The website uses cookies to provide personalized services at the highest level, including statistical services and to adapt the content to individual preferences of users. Saving cookies can be turned off in your browser settings.
OK
[zamknij]     

LOCTITE MR 5923 - 450ml (liquid sealant based on solvent, rubber modified, reddish brown)

LOCTITE MR 5923 - 450ml (liquid sealant based on solvent, rubber modified, reddish brown) (IDH.149402)

przykład użycia
Product description:
LOCTITE MR 5923 seals close fitting parts, machined surfaces and threaded connections in industrial, aircraft, andmarine applications. It is a slow drying liquid that changes to apliable, tacky film through solvent evaporation. Typical applications include solid gasket dressing, close fitting machined surfaces, threaded connections, aviation engines and marine engines. This product is typically used in applications with an operating range of -54 °C to +204 °C. Further information about the product: biuro@woronko-kleje.pl

Steps to achieve the best adhesive results:
1. Remove all previous material from mating surfaces.
2. For best results, clean and prep the area with an oil free solvent.
3. Remove cap. Coat with brush-top applicator.
4. When used as a gasket dressing, spread product with a spatula to a uniform film on one side of gasket and then position it on the assembly. Coat the second side of gasket and re-assemble. Slower drying formula increases work time.
5. Assembly is operational after 4 hours, full cure is effective after 24 hours.
6. The product can be removed from metal surfaces with isopropyl alcohol. If the sealant has been dried for a long time or at high temperatures, cover the sealant with alcohol and allow to soften overnight.

CLEAN UP:
1. Clean hands with hand cleaners.

Storage:
Store product in the unopened container in a dry location.Storage information may be indicated on the product containerlabeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during use. Do not return product to the original container. Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other thanthose previously indicated.

Parameters:
  • Chemical type: Modified resin, fillers and alcohol
  • Appearance : dark brown liquid
  • Smell : Alcohol
  • Specific gravity : 1.1
  • Viscosity : Consistency similar to SAE 10 engine oil
  • The product does not lose its properties in contact with water, ethylene glycol, gasoline, motor oil, transmission fluid and sea water.
  • Working temperature : from -50 °C to +200 °C


Full technical information can be found in the technical data sheet.

Assortment