LOCTITE FREKOTE 913 WB - 1 L (mold cleaner)
No.
IDH.1252382
Product description:
LOCTITE FREKOTE 913WB™ is a water-based cleaner for molds made from epoxy, polyester, other plastics, glass and aluminium. It removes residues from other polishing liquids. LOCTITE FREKOTE 913 WB leaves an antistatic, streak free mold surface after it was rubbed with a cloth and loaded with static electricity. Further information about the product: biuro@woronko-kleje.pl
Directions for use:
1. Apply LOCTITE FREKOTE 913 WB by spraying onto the mold surface from the bottle.
2. Distribute the applied amount of product with a clean, lint free disposable wipe.
3. Let dry for approximately 10 seconds.
4. Wipe-off with a dry paper tissue.
5. For a defined surface rinse the mold with a solvent like Frekote PMC.
6. The mold is now ready to be coated with a new release agent.
Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties. Material removed from containers may be contaminated during use. Do not return product to the original container. Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:
Appearance : clear liquid Chemical type : water based emulsion Odour : Mild citrus Cure : air dry Application temperature : 20 to 40 °C Easy application Prevents dust recontamination Non-flammable Density at 25 °C, g/ml : 0,98 to 0,99 Refractive Index : 1,335 to 1,355
Full technical information can be found in the technical data sheet
LOCTITE FREKOTE 913WB™ is a water-based cleaner for molds made from epoxy, polyester, other plastics, glass and aluminium. It removes residues from other polishing liquids. LOCTITE FREKOTE 913 WB leaves an antistatic, streak free mold surface after it was rubbed with a cloth and loaded with static electricity. Further information about the product: biuro@woronko-kleje.pl
Directions for use:
1. Apply LOCTITE FREKOTE 913 WB by spraying onto the mold surface from the bottle.
2. Distribute the applied amount of product with a clean, lint free disposable wipe.
3. Let dry for approximately 10 seconds.
4. Wipe-off with a dry paper tissue.
5. For a defined surface rinse the mold with a solvent like Frekote PMC.
6. The mold is now ready to be coated with a new release agent.
Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties. Material removed from containers may be contaminated during use. Do not return product to the original container. Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:
Full technical information can be found in the technical data sheet