LOCTITE LB 8035 - 20l (metalworking coolant)
No.
IDH.1993338
Associated products:
Product description:
LOCTITE LB 8035 is a bactericide-free water miscible cutting fluid for general machining of all steel and cast materials. Aluminium and non-ferrous metals can be co-worked on the machines. LOCTITE LB 8035 is highly resistant to microorganisms, bacteria and fungi. It provides excellent cooling and lubrication performance, good cleaning performance, excellent run-off properties and a remarkable little foam formation. LOCTITE LB 8035 prolongates tool service life resulting from extremely efficient lubrication. Further information about the product: biuro@woronko-kleje.pl
Directions for use:
1. LOCTITE LB 8035 is used in automatic machining.
2. Use a 5 to 8% concentration for the initial filling.
3. To get the cutting fluid pour the LOCTITE LB 8035 concentrate into the water.
4. Product to be fully mixed by using the machine pump.
5. For top-up use a concentration of 0,5 to 1,5%.
6. For concentration control use a refractometer.
Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during use. Do not return product to the original container. Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:
Full technical information can be found in the technical data sheet.
LOCTITE LB 8035 is a bactericide-free water miscible cutting fluid for general machining of all steel and cast materials. Aluminium and non-ferrous metals can be co-worked on the machines. LOCTITE LB 8035 is highly resistant to microorganisms, bacteria and fungi. It provides excellent cooling and lubrication performance, good cleaning performance, excellent run-off properties and a remarkable little foam formation. LOCTITE LB 8035 prolongates tool service life resulting from extremely efficient lubrication. Further information about the product: biuro@woronko-kleje.pl
Directions for use:
1. LOCTITE LB 8035 is used in automatic machining.
2. Use a 5 to 8% concentration for the initial filling.
3. To get the cutting fluid pour the LOCTITE LB 8035 concentrate into the water.
4. Product to be fully mixed by using the machine pump.
5. For top-up use a concentration of 0,5 to 1,5%.
6. For concentration control use a refractometer.
Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during use. Do not return product to the original container. Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:
- Density (20 °C), g/cm³ : 0,97
- Viscosity (20 °C), cSt : 122
- pH (5 % deionized water) : 9,2
- Flash point : see safety data sheet
Full technical information can be found in the technical data sheet.