LOCTITE LB 8031 - 400ml (oil for threading, drilling, cutting) spray
No.
IDH.1324497
Files to download:
Product description:
LOCTITE LB 8031 is a multi-purpose cutting oil used to facilitate machining operations. This product permits greater cutting speed with improved surface finish and increased tool life. It is a lubricant for wear prevention during drilling, tapping and general machining operations. Suitable for use on steel and stainless steel. However it should not be used on aluminum, titanius and copper alloy surfaces where appearance is important. This product is typically used in applications with an operating range of -20 °C to +160 °C. Further information about the product: biuro@woronko-kleje.pl
Directions for use:
1. Shake the product thoroughly before use.
2. Apply product to tool during cutting operation.
Storage:
The product is classified as HIGHLY FLAMMABLE and must be stored in an appropriate manner in compliance with relevant regulations. Do not store near oxidizing agents or combustible materials. Store product in the unopened container in a dry location. Storage information may also be indicated on the product container labelling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties.
Henkel cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:
Full technical information can be found in the technical data sheet
LOCTITE LB 8031 is a multi-purpose cutting oil used to facilitate machining operations. This product permits greater cutting speed with improved surface finish and increased tool life. It is a lubricant for wear prevention during drilling, tapping and general machining operations. Suitable for use on steel and stainless steel. However it should not be used on aluminum, titanius and copper alloy surfaces where appearance is important. This product is typically used in applications with an operating range of -20 °C to +160 °C. Further information about the product: biuro@woronko-kleje.pl
Directions for use:
1. Shake the product thoroughly before use.
2. Apply product to tool during cutting operation.
Storage:
The product is classified as HIGHLY FLAMMABLE and must be stored in an appropriate manner in compliance with relevant regulations. Do not store near oxidizing agents or combustible materials. Store product in the unopened container in a dry location. Storage information may also be indicated on the product container labelling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties.
Henkel cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:
- Chemical type : mineral oil and EP additives
- Appearance : dark yellow
- Odor : oily
- Density at 20 °C, g/ml : 0,84
- Viscosity at 40°C, cSt :170
- Pressure at 20 °C, Bar : 4.5
- Delivery rate, g/s : 2,1
- Peak temperature, °C : 200
Full technical information can be found in the technical data sheet