The website uses cookies to provide personalized services at the highest level, including statistical services and to adapt the content to individual preferences of users. Saving cookies can be turned off in your browser settings.
OK
[zamknij]     
Product description:
LOCTITE® 422™ is a general purpose cyanoacrylate instant adhesive. Mil-A-46050C LOCTITE® 422™ is tested to the lot requirements of Military Specification Mil-A-46050C.
Note: This is a regional approval. Please contact your local Technical Service Center for moreinformation and clarification.
Commercial Item Description A-A-3097:
LOCTITE® 422™ has been qualified to Commercial Item Description A-A-3097.
Note: This is a regional approval. Please contact your local Technical Service Center for more information and clarification. Further information about the product: biuro@woronko-kleje.pl
Directions for use:
1. For best performance bond surfaces should be clean and free from grease. You can use LOCTITE® SF 7063™.
2. This product performs best in thin bond gaps (0.05 mm).
3. Excess adhesive can be dissolved with Loctite cleanup solvents, nitromethane or acetone.
Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling. Optimal Storage: 2 °C to 8 °C. Storage below 2 °C or greater than 8 °C can adversely affect product properties. Material removed from containers may be contaminated during use. Do not return product to the original container. Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated. If additional information is required, please contact your local Technical Service Center or Customer Service Representative.
Parameters:
  • Fixture Time, seconds:
    - Mild Steel (degreased) : 20 to 50
    - Aluminum (degreased) : 10 to 30
    - Zinc dichromate : 40 to 100
    - Neoprene : <5
    - Rubber, nitrile : <5
    - ABS : 15 to 40
    - PVC : 20 to 50
    - Polycarbonate : 30 to 70
    - Phenolic : 10 to 40
  • Lap Shear Strength, ISO 4587 (After 24 hours at 22 °C):
    - Steel (grit blasted), N/mm² : 18 to 26
    - Aluminum (grit blasted), N/mm² : 12 to 19
    - Zinc dichromate, N/mm² : 6 to 13
    - ABS, N/mm² : 6 do 20
    - PVC, N/mm² : 6 do 20
    - Polycarbonate, N/mm² : 5 to 20
    - Phenolic, N/mm² : 5 to 15
    - Neoprene, N/mm² : 5 to 15
    - Nitrile, N/mm² : 5 to 15
  • Tensile Strength, ISO 6922:
    - Steel, N/mm² : 12 to 25
    - Buna-N, N/mm²: 5 to 15

    Full technical information can be found in the technical data sheet.
  • Assortment