TEROSON UP 270 EGFD - 558g (Self-leveling putty)
No.
IDH.2263729
Product description:
TEROSON UP 270 is the super smooth and easy to spread body filler with low viscosity and self-levelling properties. TEROSON UP 270 repairs:
● scratches
● pinholes
● imperfections
Directions for use:
Knead the foilpouche well before use. Use the amount of Body Filler according to the required repair area and mix the mass in a ratio of a golf ball size (40mL) with a 4 to 5 cm (2 to 3 %) long hardener stripe of TEROSON UP 190, using a spreader until a uniform color has been achieved. After mixing the time to apply the filler is approximately 4 to 5 minutes at 20°C. Apply the filler mixture onto the repair area in a way that the dent, scratch is sufficiently filled. Surface can be sanded after 10 to 20 minutes at room temperature. Accelerated cure, using an infrared heater (surface temperature max. 60°C) is possible after 10 minutes of the Body Filler application. Further information about the product: biuro@woronko-kleje.pl
Storage:
Frost sensitive : no Recommended storage temperature :10 to 25 °C Shelf life : 24 months in original packaging
Parameters:
Component A:
Colour : light-green Odour : styrene Density : approx. 1.27 g/cm³
Component B: Colour : red Odour : neutral Density : approx. 1.1 g/cm³
Mixture (Component A+B) Mixing ratio by volume 100: 2-3 Pot life (20 °C, 50% rh) 4.5 min. Grinding possible after 10 to 20 min.
Full technical information can be found in the technical data sheet
TEROSON UP 270 is the super smooth and easy to spread body filler with low viscosity and self-levelling properties. TEROSON UP 270 repairs:
● scratches
● pinholes
● imperfections
Directions for use:
Knead the foilpouche well before use. Use the amount of Body Filler according to the required repair area and mix the mass in a ratio of a golf ball size (40mL) with a 4 to 5 cm (2 to 3 %) long hardener stripe of TEROSON UP 190, using a spreader until a uniform color has been achieved. After mixing the time to apply the filler is approximately 4 to 5 minutes at 20°C. Apply the filler mixture onto the repair area in a way that the dent, scratch is sufficiently filled. Surface can be sanded after 10 to 20 minutes at room temperature. Accelerated cure, using an infrared heater (surface temperature max. 60°C) is possible after 10 minutes of the Body Filler application. Further information about the product: biuro@woronko-kleje.pl
Storage:
Parameters:
Component A:
Component B:
Mixture (Component A+B)
Full technical information can be found in the technical data sheet