TEROSON UP 260 - 535g (Body Filler)
No.
IDH.2246388
Product description:
TEROSON UP 260 is the fine filler as top coat for a high end surface. TEROSON UP 260 repairs:
- minor dents
- scratches
- pinholes
- imperfections
Directions for use:
Use the amount of Body Filler according to the required repair area and mix the mass in a ratio of a golf ball size (40mL) witha 4 to 5 cm (2 to 3 %) long hardener stripe of TEROSON UP 190, using a spreader until a uniform color has been achieved. After mixing the time to apply the filler is approximately 4 minutes at 20°C. Apply the filler mixture onto the repair area in a way that the dent, scratch or hole is sufficiently filled. Thicker layers should be built up using multiple layers.Surface can be sanded after 15 to 20 minutes at room temperature. Accelerated cure, using an infrared heater (surface temperature max. 60°C) is possible after 10 minutes of the Body Filler application. Further information about the product: biuro@woronko-kleje.pl
Storage:
Frost sensitive no Recommended storage temperature : 10 to 25 °C Shelf life 24 months in original packaging
Parameters:
Component A:
Colour: light grey Odour: styrene Density: approx. 1,3 g/cm³
Component B: Colour: red Odour : neutral Density : approx. 1,1 g/cm³
Mixture (Component A+B): Mixing ratio by volume : 100: 2-3 Pot life (20 °C, 50% rh) : 4 min. Grinding : possible after 15 to 20 min.
Full technical information can be found in the technical data sheet
TEROSON UP 260 is the fine filler as top coat for a high end surface. TEROSON UP 260 repairs:
- minor dents
- scratches
- pinholes
- imperfections
Directions for use:
Use the amount of Body Filler according to the required repair area and mix the mass in a ratio of a golf ball size (40mL) witha 4 to 5 cm (2 to 3 %) long hardener stripe of TEROSON UP 190, using a spreader until a uniform color has been achieved. After mixing the time to apply the filler is approximately 4 minutes at 20°C. Apply the filler mixture onto the repair area in a way that the dent, scratch or hole is sufficiently filled. Thicker layers should be built up using multiple layers.Surface can be sanded after 15 to 20 minutes at room temperature. Accelerated cure, using an infrared heater (surface temperature max. 60°C) is possible after 10 minutes of the Body Filler application. Further information about the product: biuro@woronko-kleje.pl
Storage:
Parameters:
Component A:
Component B:
Mixture (Component A+B):
Full technical information can be found in the technical data sheet