The website uses cookies to provide personalized services at the highest level, including statistical services and to adapt the content to individual preferences of users. Saving cookies can be turned off in your browser settings.
OK
[zamknij]     

LOCTITE SI 5940 CR - 310ml (silicone for sealing metal flanges, transparent)

LOCTITE SI 5940 CR - 310ml (silicone for sealing metal flanges, transparent) (IDH.229142)

Product description:
LOCTITE SI 5940 cures on exposure to moisture in the air to form a tough, flexible, waterproof, oil-resistant silicone rubber bond. This sealant is primarily used as a general purpose sealing and bonding agent, as a space-filling rubber adhesive or formed-in-place gasket. It adheres to clean metal, glass, most types of non-oily woods, silicone resin, vulcanized silicone rubber, ceramic, natural and synthetic fiber and many painted and plastic surfaces. This product is typically used in applications with an operating range of -50 °C to 200 °C and can intermittently reach temperatures up to 220 °C. Further information about the product: biuro@woronko-kleje.pl

Steps to achieve the best adhesive results:
1. For best performance bond surfaces should be clean and free from grease. Use LOCTITE SF 7063.
2. Moisture curing begins immediately after the product is exposed to the atmosphere, therefore parts to be assembled should be mated within a few minutes after the product is dispensed.
3. The bond should be allowed to cure (e.g. seven days), before subjecting to heavy service loads.
4. Excess material can be easily wiped away with non-polar solvents.

Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during use. Do not return product to the original container.
Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.

Parameters:
  • Chemical Type: acetoxy silicone
  • Appearance (uncured): Black paste
  • Cured for 7 days at 23 °C / 50% RH, on 2 mm thick sheet:
    -Shore Hardness, ISO 868, Durometer A : 22
    -Elongation, at break, ISO 37, % : 500
    -Tensile Strength, ISO 37 N/mm² : 1,8
  • Specific Gravity ( 25 °C ) : 1,02
  • Extrusion Rate, g/min : 200


Full technical information can be found in the technical data sheet.

Assortment