Try to find the solution
LOCTITE D 125 F - 30g (Orange piston, EFD)
No.
IDH.1189499
Associated products:
LOCTITE D 125 F - 30g (Orange piston, EFD)
Associated products:
Product description:
LOCTITE D 125 F surface mount adhesive is designed for high speed dispensing.
Features:
Low exotherm No stringing Low water absorption High hot strength Low cure temperature Non-sag
Further information about the product: biuro@woronko-kleje.pl
Directions for use:
1. LOCTITE D 125 F can be applied by dispensing, pin transfer, screen or stencil printing.
2. Equipment set-up and related product information is available from your Henkel Corporation support group.
Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling. Optimal Storage : 0 to 8 °C. Material removed from containers may be contaminated during use. Do not return product to the original container. Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated. If additional information is required, please contact your local Technical Service Center or Customer Service Representative
Parameters:
Technology : Epoxy Appearance : Yellow Components : One-component Cure : Heat Cure Application : Surface mount adhesive Operating Temperature : -40 to 105 °C Typical Assembly Applications : Chip capacitors, Chip resistors, SOTs, SOICs and PLCCs Physical Properties :
- Coefficient of Thermal Expansion ASTM D 3386, Below Tg, ppm/°C : 58
- Glass Transition Temperature, ISO 11357-2, °C : 85
- Coefficient of Thermal Conductivity, W/(m-K) : 0.3
- Shore Hardness, ISO 868, Durometer D : >80
- Linear Shrinkage, % : 0.5
- Degree of Conversion by DSC , %: 3 minutes at 125°C : >90 Electrical Properties:
- Dielectric Constant , IEC 60250 @ 1 MHz : 3.5
Full technical information can be found in technical data sheet
LOCTITE D 125 F surface mount adhesive is designed for high speed dispensing.
Features:
Further information about the product: biuro@woronko-kleje.pl
Directions for use:
1. LOCTITE D 125 F can be applied by dispensing, pin transfer, screen or stencil printing.
2. Equipment set-up and related product information is available from your Henkel Corporation support group.
Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling. Optimal Storage : 0 to 8 °C. Material removed from containers may be contaminated during use. Do not return product to the original container. Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated. If additional information is required, please contact your local Technical Service Center or Customer Service Representative
Parameters:
- Coefficient of Thermal Expansion ASTM D 3386, Below Tg, ppm/°C : 58
- Glass Transition Temperature, ISO 11357-2, °C : 85
- Coefficient of Thermal Conductivity, W/(m-K) : 0.3
- Shore Hardness, ISO 868, Durometer D : >80
- Linear Shrinkage, % : 0.5
- Degree of Conversion by DSC , %: 3 minutes at 125°C : >90
- Dielectric Constant , IEC 60250 @ 1 MHz : 3.5
Full technical information can be found in technical data sheet
