TEROSON RB II GY CR - 310ml (butyl sealant)
No.
IDH.150000
Associated products:
TEROSON RB II GY CR - 310ml (butyl sealant)
Associated products:
Product description:
Teroson RB II is a solvent free, permanently plastic, multipurpose sealant based on synthetic rubber. It serves as a good corrosion protection and can be painted with conventional paints based on oil and synthetic resins. The material exhibits very good water and aging resistance. Due to its tackiness the sealant adheres to most surfaces while they are clean and dry and shows excellent compatibility with a variety of substrates. Because of its characteristics Teroson RB II is used as an inner sealant when sealing overlapping substrates. The sealed parts need to be fixed mechanically, e.g. by clamps, screws, rivets or similar. Further information about the product: biuro@woronko-kleje.pl
Directions for use:
Pre-Treatment:
As far as possible the substrates must be clean, dry, free of oil and grease. Small traces of oil and fat can be absorbed by Teroson RB II.
Application:
Unroll Teroson RB II and cut it to the desired length. Then apply the tape to the surface requiring sealing and press it on. Experience has shown that it is best not to remove the release paper or film when unrolling the tape, but only after it has been applied and pressed on. In this way any unwanted stretching of the tape during application can be prevented and the sealing tape is protected from dirt. After peeling off the release paper, press on the mating part and fix the entire assembly mechanically.
Cleaning:
Excess sealant can easily be dabbed off with a piece of Teroson RB II.
Storage:Frost-Sensitive : no Recommended Storage Temperature, °C : 5 to 35 Shelf-life (in unopened original packaging), months : 24
Parameters: Density, g/cm³ : approx. 1.58 Consistency: plastic Solids, % : 100 Penetration (cone 150 g, 6 s, 23°C), mm : approx. 40 1/10 Tack : low Paint compatibility : can be painted In service temperature range, °C : -25 to 80 Short exposure (up to 1 h), °C : 150
Further information can be found in technical data sheet
Teroson RB II is a solvent free, permanently plastic, multipurpose sealant based on synthetic rubber. It serves as a good corrosion protection and can be painted with conventional paints based on oil and synthetic resins. The material exhibits very good water and aging resistance. Due to its tackiness the sealant adheres to most surfaces while they are clean and dry and shows excellent compatibility with a variety of substrates. Because of its characteristics Teroson RB II is used as an inner sealant when sealing overlapping substrates. The sealed parts need to be fixed mechanically, e.g. by clamps, screws, rivets or similar. Further information about the product: biuro@woronko-kleje.pl
Directions for use:
Pre-Treatment:
As far as possible the substrates must be clean, dry, free of oil and grease. Small traces of oil and fat can be absorbed by Teroson RB II.
Application:
Unroll Teroson RB II and cut it to the desired length. Then apply the tape to the surface requiring sealing and press it on. Experience has shown that it is best not to remove the release paper or film when unrolling the tape, but only after it has been applied and pressed on. In this way any unwanted stretching of the tape during application can be prevented and the sealing tape is protected from dirt. After peeling off the release paper, press on the mating part and fix the entire assembly mechanically.
Cleaning:
Excess sealant can easily be dabbed off with a piece of Teroson RB II.
Storage:
Parameters:
Further information can be found in technical data sheet
