The website uses cookies to provide personalized services at the highest level, including statistical services and to adapt the content to individual preferences of users. Saving cookies can be turned off in your browser settings.
OK
[zamknij]     

LOCTITE SI 5990 - 100ml (high temperature silicone for sealing metal flanges, copper color)

LOCTITE SI 5990 - 100ml (high temperature silicone for sealing metal flanges, copper color) (IDH.2064108)

Product description:
LOCTITE SI 5990 is a moisture-curing, non-corrosive silicone. The thixotropic nature of LOCTITE SI 5990 reduces the migration of liquid product after application to the substrate. It has been designed specially for gasketing and sealing applications where excellent temperature resistance is required. It is also used for electrical insulating applications. This product is typically used in applications up to 350 °C. Further information about the product: biuro@woronko-kleje.pl

Steps to achieve the best adhesive results:
1. For best performance bond surfaces should be clean and free from grease. Use LOCTITE SF 7063.
2. Moisture curing begins immediately after the product is exposed to the atmosphere, therefore parts to be assembled should be mated within a few minutes after the product is dispensed.
3. The bond should be allowed to cure (e.g. seven days), before subjecting to heavy service loads.
4. Excess material can be easily wiped away with non-polar solvents.

Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during use. Do not return product to the original container.
Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.

Parameters:
  • Chemical type: silicon
  • Specyfic gravity (22 °C) : 1,04
  • Hardness, ISO 868, scale Shore A: 27
  • Elongation at break, ISO 37, % : 270
  • Shear strength, ISO 4587 (after 21 days, w 22 °C / 50% RH, and 0,5 mm gap):
    -Cooper [N/mm²] : 0,3
    -Brass [N/mm²] : 0,23
    -Steel [N/mm²] : 0,25
    -ABS [N/mm²] : 0,1
    -Steel with a zinc coating [N/mm²] : 0,4


Full technical information can be found in the technical data sheet of the product.

Assortment