The website uses cookies to provide personalized services at the highest level, including statistical services and to adapt the content to individual preferences of users. Saving cookies can be turned off in your browser settings.
OK
[zamknij]     

LOCTITE 268 - 19g (anaerobic, red, medium/high strength threadlocker stick)

LOCTITE 268 - 19g (anaerobic, red, medium/high strength threadlocker stick) (IDH.1709318)

przykład użycia
Product description:
LOCTITE 268 is a high strength version of an anaerobic threadlocking material. It is supplied as a wax-like semi-solid, conveniently packaged in a self-feeding stick applicator. As with liquid anaerobic products, this material develops its cured properties in the absence of air when confined between close fitting metal surfaces. It achieves consistent strength and can be used on a variety of metal substrates. It is particularly well suited for applications where a liquid product may be too fluid to stay on a part or be difficult to apply. It stores easily and allows for direct contact to a threaded part during application to ensureevencoverage. Where aqueous washing systems are used to clean the surfaces before bonding, it is important to check for compatibility of the washing solution with the adhesive. In some cases these aqueous washes can affect the cure and performanceofthe adhesive. This product is not normally recommended for use on plastics (particularly thermoplastic materials where stress cracking of the plastic could result). Users are recommended to confirm compatibility of the product with such substrates. Further information about the product: biuro@woronko-kleje.pl

Steps to achieve the best adhesive results:
FOR ASSEMBLY:
1. For best results, clean all surfaces (external and internal) with a LOCTITE SF 7063 cleaning solvent and allow to dry.
2. Advance only enough product to use at the time of application.
3. Remove any skin that may have formed on the top of the stick.
4. Apply sufficient product to fill the threads in the area where the nut will be engaged on the bolt.
5. Recap product after use.
6. Assemble and tighten as required.

FOR DISASSEMBLY:
7. Where hand tools do not work because of excessive engagement length or large diameters (over 1"), apply localized heat to approximately 250 °C. Disassemble while hot.

FOR CLEAN UP:
8. Cured product can be removed with a combination of soaking in a LOCTITE SF 7200 solvent and mechanical abrasion such as a wire brush.

Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during use. Do not return product to the original container.
Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.

Parameters:
  • Thread size : to M50
  • Strength : high
  • Time to get full strength (22 °C):
    -Zinc phosphorate & oil: 8 hours
    -Black oxide: 8 hours
    -Brass: 15 minutes
    -Zinc dichromate: 4 hours
    -Stainless steel: 72 hours
  • Time to obtain initial strength (22 °C):
    -Zinc phosphorate & oil: 15 minutes
    -Black oxide: 15 minutes
    -Brass: 15 minutes
    -Zinc dichromate: 20 minutes
    -Stainless steel: 15 minutes
  • Breakaway Torque (M10 steel nuts) : 17 Nm
  • Working temperature : from -55 °C to +150 °C
  • Color : red

Full technical information can be found in the technical data sheet.

Assortment