The website uses cookies to provide personalized services at the highest level, including statistical services and to adapt the content to individual preferences of users. Saving cookies can be turned off in your browser settings.
OK
[zamknij]     

LOCTITE FREKOTE PMC - 5L (mold cleaner)

LOCTITE FREKOTE PMC - 5L (mold cleaner) (IDH.381114)

Product description:
LOCTITE Frekote PMC is a special blend of solvents designed to dissolve and remove wax from polyester molds without dulling the surface. This product can also be used to clean epoxy and metal mold surfaces as well as for cleaning brushes and equipment. LOCTITE Frekote PMC is highly recommended for preparing polyester mold surfaces prior to application of Frekote mold sealers and mold release agents. Further information about the product: biuro@woronko-kleje.pl

Directions for use:
1. LOCTITE Frekote PMC should be applied to the mold surface with a clean lint free cloth.2. Wax and other mold residue will immediately begin to dissolve and should be removed from the surface with a second clean cloth while it is still dissolved in the LOCTITE Frekote PMC.3. As the cloth becomes saturated with wax and mold residue, dispose of it and use a new cloth.4. Repeat process until composite and other mold residue is removed.5. The mold is now ready for use.6. NOTE: A simple test to assess mold cleanliness is the use of masking tape. A coated surface will allow easy release of masking tape, where as a wax free surface will allow good adhesion of masking tape. This test can also be used to determine the effectiveness of Frekote Release Interfaces. A good interface will prevent any significant degree of tape adhesion.

Storage:
The product is classified as flammable and must be stored in an appropriate manner in compliance with relevant regulations. Do not store near oxidizing agents or combustible materials. Store product in the unopened container in a dry location. Storage information may also be indicated on the product container labelling. Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties. Material removed from containers may be contaminated during use. Do not return product to the original container. Henkel cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.

Parameters:
  • Appearance : clear liquid
  • Chemical type : solvent blend
  • Odor : solvent
  • Application temperature : 20 to 30 °C
  • Specific Gravity at 25 °C : 0.821 to 0.854

    Full technical information can be found in the technical data sheet.
  • Assortment