LOCTITE SF 7515 - 20l (corrosion protection of the surface)
No.
IDH.1444143
Product description:
LOCTITE SF 7515 is a water-based corrosion protecting surface treatment for metals like aluminium, zinc, zinc alloy and cold rolled steel surfaces. This product can also be used on blasted metal surfaces as short-term corrosion protection before coating and to improve corrosion resistance of final coated metal. LOCTITE SF 7515 is a no-rinse treatment for spray and wipe applications. It is compatible with most coatings as well as most paints. Further information about the product: biuro@woronko-kleje.pl
Directions for use:
1. Apply LOCTITE SF 7515 on a clean surface by spraying or wiping, at a temperature between 20 to 40 °C.
2. Wipe off excess if necessary leaving a thin film and allow parts to dry.
3. CAUTION: LOCTITE SF 7515 contains complex fluorides in solution. Aid and handling recommendations of the MSDS should be read, understood and followed by everybody being in contact with this product.
Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties. Material removed from containers may be contaminated during use. Do not return product to the original container. Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:
Chemical type : hexafluorotitan acid Appearance: amber liquid Components : one component requires no mixing Density, g/cm³ : 1,01 pH : 2,1 do 2,7
Full technical information can be found in the technical data sheet
LOCTITE SF 7515 is a water-based corrosion protecting surface treatment for metals like aluminium, zinc, zinc alloy and cold rolled steel surfaces. This product can also be used on blasted metal surfaces as short-term corrosion protection before coating and to improve corrosion resistance of final coated metal. LOCTITE SF 7515 is a no-rinse treatment for spray and wipe applications. It is compatible with most coatings as well as most paints. Further information about the product: biuro@woronko-kleje.pl
Directions for use:
1. Apply LOCTITE SF 7515 on a clean surface by spraying or wiping, at a temperature between 20 to 40 °C.
2. Wipe off excess if necessary leaving a thin film and allow parts to dry.
3. CAUTION: LOCTITE SF 7515 contains complex fluorides in solution. Aid and handling recommendations of the MSDS should be read, understood and followed by everybody being in contact with this product.
Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties. Material removed from containers may be contaminated during use. Do not return product to the original container. Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:
Full technical information can be found in the technical data sheet