The website uses cookies to provide personalized services at the highest level, including statistical services and to adapt the content to individual preferences of users. Saving cookies can be turned off in your browser settings.
OK
[zamknij]     

LOCTITE 248 - 19g (anaerobic, blue, medium strength threadlocker stick)

LOCTITE 248 - 19g (anaerobic, blue, medium strength threadlocker stick) (IDH.1714961)

przykład użycia
Product description:
LOCTITE 248 is a medium strength anaerobic threadlocking material. It is supplied as a wax-like semi-solid, conveniently packaged in a self-feeding stick applicator. As with liquid anaerobic products, this material develops its cured properties in the absence of air when confined between close fitting metal surfaces. It achieves consistent strength and can be used on a variety of metal substrates. It is particularly well suited for applications where a liquid product may be too fluid to stay on a part or be difficult to apply. It stores easily and allows for direct contact to a threaded part during application to ensure even coverage. Further information about the product: biuro@woronko-kleje.pl

Steps to achieve the best adhesive results:
FOR ASSEMBLY:
1. For best results, clean all surfaces (external and internal) with a LOCTITE SF 7063 cleaning solvent and allow to dry.
2. Advance only enough product to use at the time of application.
3. Remove any skin that may have formed on the top of the stick.
4. Apply sufficient product to fill the threads in the area where the nut will be engaged on the bolt.
5. Recap product after use.
6. Assemble and tighten as required.

FOR DISASSEMBLY:
7. Remove with standard hand tools.
8. In rare instances where hand tools do not work because of excessive engagement length, apply localized heat to nut or bolt to approximately 250 °C. Disassemble while hot.

FOR CLEAN UP:
9. Cured product can be removed with a combination of soaking in a LOCTITE SF 7200 solvent and mechanical abrasion such as a wire brush

Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during use. Do not return product to the original container.
Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.

Parameters:
  • Thread size: to M50
  • Strength: medium
  • Time to get full strength (22 °C):
    -Zinc phosphate and oil: 8 hours
    -Oxidized: 168 hours
    -Stainless steel: 72 hours
    -Brass: 5 hours
    -Zinc dichromate: 168 hours
  • Time to obtain initial strength (22 °C):
    -Zinc phosphate and oil: 15 minutes
    -Oxidized: 15 minutes
    -Stainless steel: 15 minutes
    -Brass: 18 minutes
    -Zinc dichromate: 15 minutes
  • Breakaway Torque for nuts M10: 19 Nm
  • Working temperature : -50 °C do +150 °C


Full information can be found on the technical data sheet of the product.

Assortment