LOCTITE LB 8005 - 400ml (for belt maintenance) spray
No.
IDH.232294
Product description:
LOCTITE LB 8005 is a product in an aerosol can specifically designed for use on all types of belts to increase pulling power and to prevent belt slippage due to heat, cold, dampness or dust. It restores moisture to prevent cracking andpremature wear and extends the overall life of the belt. LOCTITE LB 8005 can be used on V- and flat belts made of rubber, leather or fabric. It is particularly suitable for all types of transmission belts in cars, trucks, busses and marine engines, but also suitable for belts in farm equipment, air conditioning units, home appliances and industrial belt drives. Further information about the product: biuro@woronko-kleje.pl
Directions for use:
1. Shake can thoroughly before use.
2. Best results are obtained when the product is at room temperature.
3. While engine is idling, spray LOCTITE LB 8005 from a distance of approximately 20 cm into the groove of the pulley which is the easiest to access.
4. Spray an even coat on all driving surfaces. A uniform, thin coat is sufficient. Avoid excessive application of the product. If liquid runs off, it indicates an over-application.
5. CAUTION: Engine is idling when spraying. It is advisable to use an extension tube whenever and wherever practical to avoid injury.
Storage:
The product is classified as flammable and must be stored in an appropriate manner in compliance with relevant regulations. Do not store near oxidizing agents or combustible materials. Store product in the unopened container in a dry location. Storage information may also be indicated on the product container labelling. Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties. Material removed from containers may be contaminated during use. Do not return product to the original container. Henkel cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:
Chemical type: pentane / acetone solvent and lubricants
Color: clear, transparent
Appearacne: liquid
Odour: petroleum solvent
Specific gravity, g/ml: 0.74
Viscosity, mPa*s : < 100
Dissolution. in water: insoluble
Propellant: CO2
Full technical information can be found in the technical data sheet
LOCTITE LB 8005 is a product in an aerosol can specifically designed for use on all types of belts to increase pulling power and to prevent belt slippage due to heat, cold, dampness or dust. It restores moisture to prevent cracking andpremature wear and extends the overall life of the belt. LOCTITE LB 8005 can be used on V- and flat belts made of rubber, leather or fabric. It is particularly suitable for all types of transmission belts in cars, trucks, busses and marine engines, but also suitable for belts in farm equipment, air conditioning units, home appliances and industrial belt drives. Further information about the product: biuro@woronko-kleje.pl
Directions for use:
1. Shake can thoroughly before use.
2. Best results are obtained when the product is at room temperature.
3. While engine is idling, spray LOCTITE LB 8005 from a distance of approximately 20 cm into the groove of the pulley which is the easiest to access.
4. Spray an even coat on all driving surfaces. A uniform, thin coat is sufficient. Avoid excessive application of the product. If liquid runs off, it indicates an over-application.
5. CAUTION: Engine is idling when spraying. It is advisable to use an extension tube whenever and wherever practical to avoid injury.
Storage:
The product is classified as flammable and must be stored in an appropriate manner in compliance with relevant regulations. Do not store near oxidizing agents or combustible materials. Store product in the unopened container in a dry location. Storage information may also be indicated on the product container labelling. Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties. Material removed from containers may be contaminated during use. Do not return product to the original container. Henkel cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:
Chemical type: pentane / acetone solvent and lubricants
Color: clear, transparent
Appearacne: liquid
Odour: petroleum solvent
Specific gravity, g/ml: 0.74
Viscosity, mPa*s : < 100
Dissolution. in water: insoluble
Propellant: CO2
Full technical information can be found in the technical data sheet