LOCTITE SF 7061 - 400ml (metal degreasing agent) spray
No.
IDH.142471
Product description:
LOCTITE SF 7061 is a non-CFC solvent based formulation for cleaning and degreasing of surfaces to be bonded withLOCTITE adhesives. The product is used as a final pre-assembly cleaning treatment to remove most greases, oils, lubrication fluids, metal cuttings and fines from surfaces to be bonded. Its high solvent power allows it to be very effective in other degreasing or part-cleaning applications. Further information about the product: biuro@woronko-kleje.pl
Steps to achieve the best adhesive results:
1. Treat surfaces to be bonded by generously spraying with LOCTITE SF 7061.
2. Wipe surfaces when still wet with a clean cloth to remove all heavy contamination. If necessary, spray surfaces again to allow run-off of product.
3. Spray surfaces again, preferably with surfaces in vertical position to allow run-off of the cleaner.
4. Allow LOCTITE SF 7061 to fully evaporate from parts prior to bonding to avoid solvent entrapment within the bond joint.
5. Apply the LOCTITE adhesive immediately after drying and assemble bond.
Storage:
The product is classified as flammable and must be stored in an appropriate manner in compliance with relevant regulations. Do not store near oxidizing agents or combustible materials. Store product in the unopened container in a dry location. Storage information may also be indicated on the product container labelling. Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties. Material removed from containers may be contaminated during use. Do not return product to the original container. Henkel cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:
Full technical information can be found in the technical data sheet.
LOCTITE SF 7061 is a non-CFC solvent based formulation for cleaning and degreasing of surfaces to be bonded withLOCTITE adhesives. The product is used as a final pre-assembly cleaning treatment to remove most greases, oils, lubrication fluids, metal cuttings and fines from surfaces to be bonded. Its high solvent power allows it to be very effective in other degreasing or part-cleaning applications. Further information about the product: biuro@woronko-kleje.pl
Steps to achieve the best adhesive results:
1. Treat surfaces to be bonded by generously spraying with LOCTITE SF 7061.
2. Wipe surfaces when still wet with a clean cloth to remove all heavy contamination. If necessary, spray surfaces again to allow run-off of product.
3. Spray surfaces again, preferably with surfaces in vertical position to allow run-off of the cleaner.
4. Allow LOCTITE SF 7061 to fully evaporate from parts prior to bonding to avoid solvent entrapment within the bond joint.
5. Apply the LOCTITE adhesive immediately after drying and assemble bond.
Storage:
The product is classified as flammable and must be stored in an appropriate manner in compliance with relevant regulations. Do not store near oxidizing agents or combustible materials. Store product in the unopened container in a dry location. Storage information may also be indicated on the product container labelling. Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties. Material removed from containers may be contaminated during use. Do not return product to the original container. Henkel cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.
Parameters:
- Solvent: acetone/alcohol
- Appearance: colorless
- Specific gravity at 25°C: 0.8
- Viscosity at 20°C, mPa· s (cP): 2
- Limit concentration value, (ACGIH), ppm: 813
- Corrosivity: none
- Drying time at 20°C, sec: 60
Full technical information can be found in the technical data sheet.